Page 2 - Installation; Unpacking
! Packaging materials are not childrens toys. Levelling 1. Install the machine on a flat sturdy floor, without resting it up against walls, cabinets etc. 2. Compensate for any unevenness by tightening or loosening the adjustable front feet. When adjusting the feet, use a spirit level to check the ma...
Page 3 - Technical Details
The first wash cycle Once the appliance has been installed and before youuse it for the first time, run a wash cycle without detergent and no laundry, setting the 90˚C programme without a pre-wash cycle. Models A1600WD, A1400SWD, A1400WD, A1200WD 59.5cm wide Dimensions 85cm high60cm deep Capacity fr...
Page 4 - Washer Dryer Description; Control panel - Model A1200
Washer Dryer Description 4 GB Control panel - Models A1600 and A1400 Control panel - Model A1200 TEMPERATURE knob: To set the temperature or the cold wash cycle ( see Starting and Programmes ). ON/OFF button: To turn the machine on and off. START/RESET button: To start the programme or cancel any in...
Page 6 - Starting and Programmes; Briefly: starting a programme; Programme table
6 GB Starting and Programmes 5. Set the spin speed ( see Personalisation ). 6. Add the detergent and any fabric softener ( see Detergents and Laundry ). 7. Start the programme by pressing the START/RESET button for at least 2 seconds. 8. When the programme is finished, the ON-OFF / DOOR LOCK LED wil...
Page 7 - Functions; Setting the temperature; Personalisation
7 Functions To enable a function:1. press the button corresponding to the desired function, according to the table below. 2. the function is enabled when the corresponding LED is illuminated. ● The rapid flashing of the button indicates that the corresponding function cannot be selected for the prog...
Page 8 - Drying Section; Drying programmes
Drying Section 8 GB ! If your machine is not permanently plumbed in, turn on the cold water supply and hook the drain hoseover the sink to enable the condensing action to work. ! The dryer is intended for use only where water is used for the cleaning process. ! Be careful not to touch the drum at th...
Page 9 - Drycare tips
9 Important information: ! A 20 minute ‘cool tumble’ is included at the end of drying, allowing fabrics to cool down, minimisingcreasing. ! A spin cycle may be carried out during drying if you have set a cotton programme. ! The sensor dry function can be used on either the cotton (HIGH heat) or synt...
Page 10 - Detergent dispenser; Maximum load size; Special items; Detergents and Laundry
Detergent dispenser ! Do not put any items into the drawer, other than detergents designed to be released from the drawer,as they may cause damage or blockage. 1. Pre-wash detergentcompartment.Maximum 200ml powderor 100ml liquid 2. Main wash detergentcompartment.Maximum 400ml powderor 200ml liquid 3...
Page 11 - General safety; Disposal; Precautions and advice
! The machine was designed and built in compliance with the applicable international safety regulations.The following information is provided for your safetyand should consequently be read carefully. General safety ● This machine should only be used by adults and in accordance with the instructions ...
Page 12 - Care and maintenance; Switching off the electricity
Caring for your appliance door anddrum ● Always leave the appliance door ajar to prevent unpleasant odours from forming. Checking the water inlet hose Check the water inlet hose at least once a year. If yousee any cracks, replace it immediately: during the wash cycles, high water pressure couldcause...
Page 13 - Troubleshooting
Troubleshooting Problem: The machine won’t start? The wash cycle won’tstart? The machine fails to fillwith water? The machine continuouslyfills with water and drains? The machine does notdrain or spin? Possible causes / Solution: ● The appliance is not fully plugged into the socket. ● There has been...
Page 15 - Spare Parts; Service; Before calling the Service Centre:
Spare Parts This appliance is a complex machine. Repairing it yourself or having a non-authorised person try to repairit could cause harm to one or more persons, coulddamage the machine and could invalidate the spareparts warranty.Call an authorised technician if you experience problems while using ...