Ariens 1024- Manuals

Ariens 1024– User Manual in PDF format online.

Manuals:

User Manual

User Manual Ariens 1024

Summary

Page 2 - WALK BEHIND SNOW THROWER; ARIENS

2 April, 2002 MODEL CERTIFICATE OF CONFORMITY ISSUED BY THE MANUFACTURERCERTIFICAT DE CONFORMITÉ DU MODÈLE DÉLIVRÉ PAR LE FABRICANT MODELL-KONFORMITÄTSBESCHEINIGUNG AUSGESTELLT DURCH DEN HERSTELLERCERTIFICATO DI COMFORMITÀ DEL MODELLO RILASCIATO DAL PRODUTTORECERTIFICADO DE CONFORMIDAD DEL MODELO PR...

Page 3 - WARNING

3 April, 2002 Stated Sound Power Levels are established following Annex V “Internal Control of Production” of directive 2000/14/EC and assessment procedure EN-ISO 3744:1995. Les déclarations de niveau de puissance acoustique sont établies conformément à l'Article V « Contrôle interne de la productio...

Page 4 - CONTROLS AND FEATURES

4 ENGLISH 1. Traction Drive Clutch Lever 2. Throttle (Engine Stop)3. Choke Control Knob4. Differential Lock (924117, 300, 505, 506, 508) 5. Ignition Key, push-pull (924116, 117) 6. Primer Bulb7. Muffler Guard8. Discharge Chute Deflector 9. Runner 10. Solenoid Compartment (924300, 505, 506, 508) 11. ...

Page 6 - DISCLAIMER; TABLE OF CONTENTS

GB - 6 Controls and Features . . . . . . . . . . . . . . . . 4 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Maintenance . . . . . . . . . . . . . ....

Page 7 - SAFETY

GB - 7 NOTE: To locate your nearest Ariens Dealer, call 1-800-678-5443 or go to www.ariens.com on the internet. 2. Understand all Safety Precautions provided in the manuals. 3. Review control functions and operation of the unit. Do not operate the Sno-Thro unless all controls function as described i...

Page 9 - Walk Around Inspection

GB - 9 3. DANGER! 4. HOT SURFACES! ASSEMBLY SAFETY RULES Read, understand, and follow all safety practices in Owner/Operator Manual before beginning assembly. Failure to follow instructions could result in personal injury and/or damage to unit.ALWAYS remove key and/or wire from spark plug before ass...

Page 10 - Operation; Hazardous Slopes

GB - 10 Never direct discharge towards persons or property that may be injured or damaged by thrown objects. Use extreme caution on gravel surfaces. Stay alert for hidden hazards or traffic. Adjust Runners so Scraper Blade does not contact gravel.DO NOT throw snow any higher than necessary.Deflected...

Page 11 - Spark Arrester; FUEL SAFETY RULES; Battery Electrolyte First Aid; STORAGE SAFETY RULES

GB - 11 Spark Arrester This product is equipped with an internal combustion type engine. DO NOT use unit on or near any unimproved, forest-covered or brush covered land unless exhaust system is equipped with a spark arrester meeting applicable local, state or federal laws. A spark arrester, if it is...

Page 12 - Handlebar and Shift Rod; ASSEMBLY

GB - 12 ACCESSORY AND ATTACHMENT SAFETY RULES Use only attachments or accessories designed for your unit. Check components frequently. If worn or damaged, replace with manufacturer’s recommended parts. Tools Required: • Pliers • Open-End Wrenches: 3/8, 7/16, 1/2, 9/16" and/or Adjustable Wrench •...

Page 14 - OPERATION

GB - 14 Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your dealer...

Page 16 - Discharge Chute Deflector; Discharge Chute; Heated Handles; FILLING FUEL TANK

GB - 16 Discharge Chute Deflector ALWAYS position discharge chute deflector at a safe angle before starting engine.DO NOT throw snow any higher than necessary.Push deflector handle forward or down to throw snow lower. Pull deflector handle up or to the rear to throw snow higher. IMPORTANT: If Chute ...

Page 17 - Check Dual Handle Interlock; TO STOP IN AN EMERGENCY; Manual Start

GB - 17 7. ALWAYS clean up any spilled fuel. PRE-START 1. Frozen Impeller IMPORTANT: Before starting engine, check impeller to be sure it is not frozen.To check impeller: 1. With key in “Stop” position, squeeze Attachment Clutch Lever to Engaged position. 2. Pull Recoil Starter Handle. 3. If Impelle...

Page 18 - Shut Off; SNOW REMOVAL; Tips for Operation; TRAVELING

GB - 18 Electric Start (120V) 1. Connect extension cord to prongs on starter. IMPORTANT: Prevent damage to unit. Know voltage of your starter and only use matching outlets. 2. Plug extension cord into 120V 3-wire, grounded outlet. 3. Turn discharge chute straight ahead.4. Make sure that the traction...

Page 19 - CHECK FASTENERS; MAINTENANCE; MAINTENANCE SCHEDULE

GB - 19 TRANSPORT ALWAYS shut off engine, remove key and drain fuel when transporting unit on a truck or trailer.Use extra care when loading or unloading unit onto trailer or truck. Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.DO NOT transport ma...

Page 20 - Auger Shaft

GB - 20 CHECK CLUTCHES Auger / impeller must stop within 5 seconds when attachment clutch/impeller brake lever is released.Wheels must stop quickly when traction drive clutch lever is released.If clutches do not engage or disengage properly, adjust or repair before operation (see Service and Adjustm...

Page 21 - Terminals; SERVICE AND ADJUSTMENTS

GB - 21 CLEAN BATTERY (924300, 505, 506, 508) IMPORTANT: Battery is maintenance free. Do not tamper with or attempt to open battery. See Service and Adjustments for charging procedures. Terminals Keep battery and its terminals clean. IMPORTANT: Remove battery from unit before cleaning.Remove corrosi...

Page 22 - DISCHARGE CHUTE

GB - 22 DEFLECTOR REMOTE (924116, 505, 506) Deflector must stay in selected position while throwing snow.If deflector does not stay in set position: 1. Tighten nut beneath the control panel to increase friction on pressure flange (Figure 12). If deflector does not follow full range of travel: 1. Pus...

Page 25 - DRIVE CHAIN; Remove old attachment drive belt:

GB - 25 TRACTION DRIVE CLUTCH ADJUSTMENT If drive slips, adjust traction clutch to compensate for friction disc wear.To adjust traction clutch: 1. Place speed selector in First (1) Forward.2. Place unit in service position.3. With traction clutch disengaged turn wheels while tightening adjustment nu...

Page 26 - Install new attachment drive belt:

GB - 26 Install new attachment drive belt: 1. Place new attachment belt onto attachment pulley. 2. Tip housing and frame back together and secure with cap screws. 3. Place belt onto engine sheave.4. Make sure engine sheave and attachment pulley align. If alignment is necessary, loosen attachment pul...

Page 27 - FRICTION DISC REPLACEMENT; Charging

GB - 27 7. Reconnect chute crank and secure with spring clip. If equipped, reconnect remote cap deflector cable and/or electric chute wire harness. 8. Replace belt cover. TRACTION DRIVE BELT REPLACEMENT NOTE: Housing and frame must be tipped apart and attachment drive belt removed from engine sheave...

Page 28 - STORAGE; TROUBLESHOOTING; PROBLEM

GB - 28 SHORT TERM IMPORTANT: NEVER spray unit with high pressure water or store unit outdoors.Run with attachment clutch engaged a few minutes after each use to free unit of any loose or melting snow.Inspect unit for visible signs of wear, breakage or damage.Keep all nuts, bolts and screws properly...

Page 29 - SERVICE PARTS; ACCESSORIES

GB - 29 To obtain a complete parts manual, find your model and serial number. Then go to www.ariens.com or call 1-800-678-5443. * Available in CE countries. Small rubber beads collect in frame 1. Friction disc wear. 1. Normal friction disc wear. Chunks or large pieces of rubber mean friction disc sh...

Page 30 - SPECIFICATIONS; Engine

GB - 30 SPECIFICATIONS Model Number 924116 924117 924300 924508 924505 924506 Description 1028 1024 1024 1128 1332 1336 Engine - Tecumseh HMSK10- 159468X OHSK100- 221608C OHSK10- 221609C OHSK11- 221716C OHSK130-223815D Power Max - HP (kW) 10 (7.46) 11 (8.2) 13 (9.7) Fast Idle Speed - RPM (min -1 ) 3...

Page 32 - Year Limited Sno-Thro Warranty

GB - 32 3 Year Limited Sno-Thro Warranty Ariens Company warrants to the original purchaser that consumer products manufacturedby Ariens Company will be free from defects in material and workmanship for a periodof three (3) years after the date of purchase, and will repair any defect in material orwo...