Arcam DT91 - Manuals - manualsarea.com

Page 2 - ATTENTION; Safety guidelines; Important safety instructions; Safety compliance

DT91 E-2 E n g li s h DT91 E-3 RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR ATTENTION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel.WARNING: To reduc...

Page 3 - Contents; Using this handbook

DT91 E-2 E n g li s h DT91 E-3 Contents Safety guidelines ....................................... E-2 Important safety instructions ................. E-2Safety compliance ................................ E-2Using this handbook.............................. E-3Positioning the unit ......................

Page 4 - Installation; Positioning the unit

DT91 E-4 E n g li s h DT91 E-5 Installation POWER INLET 115/230V A E R I A L I N P U T L R AUDIO OUTPUTS 1 2 COAX OPTICAL D I G I TA L O U T REMOTE IN PROGRAM RS232 SUPPLY VOLTAGE 115V 230V Positioning the unit n Place the DT91 on a level, fi rm, surface, avoiding direct sunlight and sources of heat...

Page 5 - Setting up the aerial; DAB

DT91 E-4 E n g li s h DT91 E-5 Setting up the aerial Your new Arcam tuner is capable of superb reception, but only if it is receiving a good quality transmission signal.If the transmission signal is strong in your area then the supplied indoor aerial may be sufficient (it should be hung on a wall wi...

Page 6 - Using your tuner; Searching for radio stations: DAB

DT91 E-6 E n g li s h DT91 E-7 Using your tuner Searching for radio stations: DAB When using the DAB tuner section for the fi rst time, you should perform a search to fi nd the available services in your area. You may also wish to repeat the search periodically to discover if any new ensembles (i.e....

Page 7 - Search for radio stations: FM; Programming a preset radio station; Changing the display mode

DT91 E-6 E n g li s h DT91 E-7 Search for radio stations: FM To perform a search Ensure that the DT91 is in FM mode (by pressing the DAB/FM button until ‘FM’ is shown on the display).There are two methods to search for stations in FM mode. If you know the broadcast frequency of the station you want,...

Page 8 - The CR-389D remote control

DT91 E-8 E n g li s h DT91 E-9 The CR-389D remote control FM DAB PROG DISP RPT MODE BAND 1-9 2-10 3-11 FM DAB SEL TUNER CR-389 CD AMPLIFIER VCR DVD TAPE AV TUNER CD AUX PHONO ENTER SP1 SP2 DISP MENU DISP 4-12 5-13 6-14 7-15 8-16 FM/DAB Use this button to switch between FM and DAB mode. The LED above...

Page 9 - Technical specifications

DT91 E-8 E n g li s h DT91 E-9 Technical specifications Digital audio output Format SPDIF co-axial to gold-plated phono socketsSPDIF optical to TOSLINK Sample rate 48kHz (DAB mode)32kHz (FM mode) Output impedance (co-axial) 75Ω unbalanced Analogue audio output Connectors Two pairs of stereo outputs ...

Page 10 - Guarantee; On line registration

DT91 E-10 E n g li s h DT91 E-11 Remote-control codes Power commands Command Decimal Code Power on 123 Power off 124 Tuner control commands Command Decimal Code Select DAB 126 Select FM 127 MENU 61 or 125 DISP 18 or 71 1–9 1 or 91 2–10 2 or 92 3–11 3 or 93 4–12 4 or 94 5–13 5 or 95 6–14 6 or 96 7–15...

Page 11 - Appendix: Serial programming interface; Introduction; Command and response formats

DT91 E-10 E n g li s h DT91 E-11 Appendix: Serial programming interface Introduction This section of the document describes the remote control protocol for controlling the DT91 via the RS232 interface. Conventions n The remote controller is referred to as the ‘RC’. n All values in this section are h...

Page 12 - Command Specifications / Spécifications des commandes /

DT91 E-12 E n g li s h DT91 E-13 Command Specifications / Spécifications des commandes / Befehlsspezifikationen / Opdrachtspecificaties Power / Alimentation / Betrieb / Stroom �� Change the stand-by state of the DT91. � Permet de modifier l'état de veille du DT91. � Ändern des Stand-by-Zustands des ...