Amana W10296137A-SP - Manuals

5 Install leveling legs WARNING Excessive Weight Hazard Use two or more people to move and install dryer.Failure to do so can result in back or other injury. 1. To avoid damaging the floor, use a large flat piece of cardboard from the dryer carton. Place cardboard under the entire back edge of the d...

6 Electrical Connection Power Supply Cord WARNING Fire Hazard use a new ul listed 30 amp power supply cord. use a ul listed strain relief. Disconnect power before making electrical connections.Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) m...

11 4. Connect the other wires to outer terminal block screws. Tighten screws. 5. Tighten strain relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. Connect a separate copper wire (G) from the external ground conductor screw (A) to...

12 Clamps: Use clamps to seal all joints. ■ Exhaust vent must not be connected or secured with screws ■ or other fastening devices that extend into interior of vent and catch lint. Do not use duct tape. Clamp Exhaust: Recommended hood styles. Acceptable hood style. 4" (102 mm) 2 ½" (64 mm) 4...

13 level Dryer Check the levelness of the dryer. Check levelness first side to side, then front to back. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. noTE: It might be necessary to level the dryer again aft...