Amana VTC Series- Manuals

4 • Ensure a minimum clearance of three (3) inches around the unit for adequate airflow. • Ensure the condensate drain is unobstructed and leak- free. NOTE: The wall sleeve has a 3/4 NPT nipple located in thebottom for connection to the drain. A trap may be requiredin the condensate drain line to pr...

5 UNIT INSTALLATION 1. Lift the unit onto the base of the sleeve and slide the unit forward until it is 1/2” away from the top inside edge ofthe sleeve to engage the seal. Ensure the unit iscompletely seated on all four sides against the wallsleeve seals. Figure 3 2. Connect properly sized electrica...

6 The unit comes with a factory-supplied quick disconnect,however, the contractor is responsible for providing overcurrent protection on the branch circuit. Refer to the unitwiring diagram for single point electrical connection. These units are provided with a Class 2 transformer for 24volt control ...