Amana IC6- Manuals

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; Introduction; RECOGNIZE THIS SYMBOL AS A; Safety Instructions; W ARNING; CAUTION; • Confirm water pressure to water valve is

2 SAVE THESE INSTRUCTIONS CAUTION ! To avoid risk of personal injury or propertydamage, do not place fingers or hands on oraround the automatic icemaking mechanismwhile the refrigerator is plugged in. IMPORTANT SAFETY INSTRUCTIONS Introduction ! RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION Read enti...

Page 3 - Water fills the empty cube mold when the; HOW THE ICEMAKER WORKS; The feeler arm senses when the bin is full; When frozen, the cubes are moved up and

3 1. Water fills the empty cube mold when the freezer has cooled to freezing temperature.Cold air is forced directly over the mold. HOW THE ICEMAKER WORKS 3. The feeler arm senses when the bin is full and signals the icemaker to stop ejectingmore cubes. However, the mold has beenrefilled and cubes f...

Page 4 - HOW TO USE YOUR ICEMAKER

4 HOW TO USE YOUR ICEMAKER 1. To start the Icemaker, lower the feeler arm to the ON (down) position. Make sure the ice storagebin is below the icemaker and pushed back asfar as possible. Arm down —icemaker will operate Arm up —stops operation 2. When the Icemaker is first connected or after any exte...

Page 5 - Read these instructions all the way through before starting.; • Do not use a self piercing saddle valve!

5 IC-6 ICE MAKER KIT INSTALLATION INSTRUCTIONS • Read these instructions all the way through before starting. • IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. • Installer—Be sure to leave these instructions with the Consumer. CAUTION ! For your safety, unplug the refrigerator fromits electri...

Page 6 - PREPARE THE FREEZER COMPARTMENT; REMOVE THE ICE SERVICE RACK; REMOVE ELECTRICAL AND; INSTALL WATER FILL TUBE THROUGH; REMOVE ALL BASKETS AND

6 PREPARE THE FREEZER COMPARTMENT 2. REMOVE THE ICE SERVICE RACK (some models) On some models, an ice service rack is mounted on two screws in the freezer side wall. If your refrigerator has an ice service rack: a. Remove ice trays and storage bin.b. Remove the two screws and discard screws and wash...

Page 7 - e. From the back, push gently on the water

7 c. To prevent the styrofoam insulation beads from entering the water fill tube duringinstallation, temporarily cover the end ofthe tube with masking tape. Push thewater fill tube through the hole. d. From the inside of the freezer, pull the water fill tube through the hole in the backwall. Be sure...

Page 9 - a. Remove and retain screws from water; c. Remove wire harness from water valve

9 INSTALL THE WATER VALVE FOR 36" WIDE BOTTOM FREEZER MODELS FOR 36" WIDE BOTTOM FREEZERMODELS a. Remove and retain screws from water valve cover plate using a ¼" hex socketand driver. Water valve cover plate b. Remove wire harness attached to cover plate by squeezing wire tie with plier...

Page 10 - INSTALL THE ICE MAKER

10 INSTALL THE ICE MAKER 4. HANG THE ICEMAKER ON FREEZER WALLa. Slip the stainless steel clip over the wall of the water cup. Stainless steel clip b1.Top mount only: Cover the tip of a knife blade with masking tape to protect the inside of the freezer. Carefully pry out and discard the white plastic...

Page 11 - CONNECT REFRIGERATOR TO WATER SUPPLY

11 CONNECT REFRIGERATOR TO WATER SUPPLY 1. CONNECT COPPER TUBING TO REFRIGERATOR. Before making connection to the refrigerator, be sure refrigerator power cord is not plugged into wall outlet. a. Turn water on and flush out the water supply tubing, making certain that allforeign matter is removed fr...

Page 12 - TROUBLE SHOOTING GUIDE; TOPIC

12 TROUBLE SHOOTING GUIDE TOPIC POSSIBLE CAUSE SOLUTION Ice maker appears to have Ice maker arm is not in correct position Confirm ice maker arm is down. See Automatic Ice stopped operating Maker section in your owner’s manual for details. Electrical power cord may not be plugged in Make sure plug f...

Page 13 - For more information on this and other Amana

13 TOPIC POSSIBLE CAUSE SOLUTION Icemaker is not producing Freezer section not operating at proper Confirm that freezer section is operating at proper ice (some models) temperature. temperature. Adjust accordingly. (continued from previouspage) Ice maker is not producing Ice maker has just recently ...

Page 14 - WARRANTY; Ice Maker; First Year; Warranty Is Void If; Owner’s Responsibilities

14 WARRANTY Ice Maker Full One Year Warranty First Year Amana Appliances will repair or replace, free of charge, any part which is defective due to workmanshipor materials. Warranty Limitations • Begins at date of original purchase. • Applies to product used within the UnitedStates or in Canada if p...