Amana AM30LP-P- Manuals

1. Using a utility knife, cut the tape to open top flaps of carton. 2. Remove Assembly/Installation Instructions and Use and Care Guide. 3. Remove the large cardboard panels on the top and each side of the inside of the carton. 4. Remove the cart base on the top of the inside of the carton. 5. Remov...

ASSEMBLED GRILL VIEW A B C F D E G H I J A. Control knob: main burnersB. Side shelfC. Grilling/cooking surfaceD. Roll top grill hoodE. Hood handleF. Bread warming rack G. Side burnerH. Control knob: side burnerI. Electronic igniter: main burners and side burner J. DrawersK. Cart door K 7

ASSEMBLY INSTRUCTIONS Step 1: Assemble Wheel Channels 1. Remove the four (4) caster assembly nuts and two (2) bolts from the wheel channel assemblies. Note: The nuts and bolts are hand tightened to the wheel channels. 2. Set the cart base on the floor and then lay the wheel channel left on the left ...

Step 2: Assemble Grill Cart 1. Place the cart side left onto the two (2) outer caster assembly bolts, make sure the large flange is toward the front of the cart base. 2. Secure the cart side left in place by tightening the caster assembly nuts onto the caster assembly bolts. 3. Use six (6) self-tapp...

1. Take the side burner package out from inside the grill head. 2. Tilt the grill head on its back and loosen the four (4) grill mounting bolts so that there is approxi- mately 1/4” between the bolt head and grill bottom. Note: The bolts are already attached to the grill head bottom. 3. Unpack the s...

ASSEMBLY INSTRUCTIONS Step 4: Assemble Drawers 1. With a Phillips head screwdriver, remove the two phillips pan head screws from the handle , then attach the handle to the drawer front face by these screws. 2. Carefully insert the drawer tray bottom into the gap at the bottom of the drawer front fac...

ASSEMBLY INSTRUCTIONS Step 5: Assemble Cart Door 1. Remove the two phillips pan head screw on the cart door handle and use these two screws to install the handle on to the cart door right. 2. Place cart door right on an angle over the right door pivot. 3. Tilt the top of the door toward the grill, w...

18 ASSEMBLY INSTRUCTIONS Step 6: Assemble Side Shelf Left 1. Loosen the Four (4) 5/16-24 hex head screws located on the left grill side. 2. Attach the left side shelf by inserting the four (4) screws on the side of the grill head into the four (4) keyhole slots on the left side shelf. 3. Tighten all...

1. Open side burner cover. 2. Remove the brass burner cap attached with tape along with side burner grate and set aside. 3. Loosen the four (4) 5/16-24 hex head screws. 4. Attach the side burner shelf by inserting the four (4) screws on the side of the grill head into the four (4) keyhole slots on t...

ASSEMBLY INSTRUCTIONS Step 8: Assemble the Side Valve & igniter module 1. Unscrew the igniter button cap and the plastic nut from the igniter module. Insert the neck of the igniter module to the round hole on the shelf front face. Then use the plastic nut to secure the igniter module in position...

ASSEMBLY INSTRUCTIONS Step 9: Assemble the Side Burner Casting 1. Remove the two phillips pan head screws from the side burner casting. 2. Angle the side burner casting and insert it into the center hole on the side burner tray. 3 Slide the side burner casting back in position to get the side burner...

ASSEMBLY INSTRUCTIONS Step 10: Assemble Igniter Wires A A. Igniter module B. Side burner igniter wire C. Main burner igniter wires B C 1. Connect loose igniter wires from the grill to the open terminals of the igniter. Note: The igniter is designed in such a way that it does not matter which termina...

ASSEMBLY INSTRUCTIONS Step 11: Assemble the Side Burner Accessories 1. Center the brass burner cap on top of the side burner head. 2. Place the side burner grate onto the side burner tray. Position the 3 longer legs of the grate into the holes around the side burner. A. Brass burner cap B. Side burn...

ASSEMBLY INSTRUCTIONS Step 12: Assemble the Drip Pan 1. Pull out the top drawer. 2. Open the right cart door. 3. Slide the drip pan onto the drip pan guides underneath the grill head assembly. A B A. Drip pan B. Drip pan guides 25

26 A B C A. Flavor grids B. Main cooking grates C. Bread warming rack 1. Insert the flavor grids into the cutouts with triangle ridges facing up. 2. Install main cooking grates on the ledges provided on the grill to create the cooking surface. 3. Slide the warming rack through the cutouts in the hoo...

27 INSTALLATION REQUIREMENTS Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas. Do not obstruct flow of combustion and ventilation air. Clearance to combustible construction: ■ A minimum of 24” (61 cm) from grill hood side...

Product Dimensions 53.625” (136.3cm) 45” (114.4cm) 33.875” (86.1cm) 29” (73.8cm) 13.125” (33.4cm) 21” (53.3cm) 20.2” (51.3cm) Observe all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must co...

Gas Supply Line Pressure Testing Testing above ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge): The grill and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than ½ psig (3.5 kPa). Testing below...

30 OUTDOOR GRILL USE Control Panel OFF P US H & T UR N H L M OFF P US H & T UR N H L M OFF P U S H & T UR N H L M A B C E D A. Left burner control knob B. Middle Left burner control knob C. Middle right burner control knob D. Right burner control knob E. Igniter button F. Side burner con...

Using Your Outdoor Grill (cont.) Manually Lighting Grill 1. Do not lean over the grill. 2. Remove the manual lighting extension and attach a match to the split ring. 3. Strike the match to light it. 4. Guide the lit match between the grill grate and one of the slots in the flavor grid. 5. Push in an...

TIPS FOR OUTDOOR GRILLING 32 Before Grilling ■ Thaw food items before grilling. ■ Lightly oil the grill grates or the food when cooking low-fat cuts of meat, fish or poultry, such as lean hamburger patties, shrimp or skinless chicken breasts. ■ Using too much oil can cause gray ash to deposit on foo...

OUTDOOR GRILL CARE Replacing the Igniter Battery If igniters stop sparking, the battery should be replaced. 1. Unscrew igniter button cap counter clockwise to remove. 2. Remove battery from the battery compartment. 3. Replace with a new alkaline “AA” size battery. Install battery with negative end i...

TROUBLE SHOOTING Grill will not light ■ Is the 20 lb LP gas fuel cylinder valve turned off? Turn the 20 lb LP gas fuel cylinder on. ■ Is the grill properly connected to the gas supply? Contact a trained repair specialist or see Installation Instructions. ■ Is there gas in the 20 lb LP gas fuel cylin...

37 REPLACEMENT PARTS Hood Assembly Front Face Overlay FCTG2908001 FCTG2908006 1 set 1 set Hood Handle Amana Logo FCTG2908002 FCTG2608008 1 pcs 1 pcs Temp Guage Front Face Heat Shield FCCS0007030 FCTG2908007 1 pcs 1 pcs Hood Support Assy. Manifold & Valve Assy. FCTG2908003 FCTG2908008 1 set 1 pcs...

AMANA® is a registered trademark of Maytag Corporation or its related companies and is used under license to Sure Heat Manufacturing © 2008.All rights reserved. RACEZ00044A 11/07 Printed in China LIMITED WARRANTY Sure Heat Mfg warrants that for 2 years from the date of purchase, the stainless steel ...