Amana AER6303MFB - Manuals

7 Location Requirements IMPORTANT: Observe all governing codes and ordinances. � It is the installer’s responsibility to comply with installationclearances specified on the model/serial/rating plate. Themodel/serial/rating plate is located on the frame behind a topcorner of the door or either side o...

8 Electrical Requirements – U.S.A.Only If codes permit and a separate ground wire is used, it isrecommended that a qualified electrical installer determine thatthe ground path and wire gauge are in accordance with localcodes. Do not use an extension cord. Be sure that the electrical connection and w...

9 INSTALLATION Unpack Range WARNING Excessive Weight Hazard Use two or more people to move and install or uninstallappliance. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do no...

12 � Tighten strain relief screw against the power supply cord. Style 2: Direct wire strain relief � Remove the knockout as needed for the flexible conduitconnection. � Assemble a UL listed conduit connector in the opening. A. Removable retaining nutB. Conduit � Tighten strain relief screw against t...

13 5. Use 3/8" (9.5 mm) nut driver to connect the neutral (white)wire to the center terminal block post with one of the 10-32hex nuts. A. 10-32 hex nutB. Ground-link screwC. Line 2 (red) D. Green ground wireE. Neutral (center) wireF. Line 1 (black) 6. Connect line 2 (red) and line 1 (black) wire...

16 Level Range Determine if you have AquaLift ® Technology or Steam Clean by referring to the “Range Maintenance and Care” section. For Ranges with AquaLift ® Technology or Steam Clean: 1. Place level on the oven bottom as indicated in one of the twofigures below depending on the size of the level. ...

17 Storage Drawer (on some models) The storage drawer can be removed. Before removing, make suredrawer is cool and empty. To Remove: 1. Pull the storage drawer straight back to the drawer stop. A. Drawer stop notch 2. Lift up the front of the drawer and pull the drawer out. To Replace: 1. Lift up th...

5 Electrical Requirements - U.S.A. Only If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Do not use an extension cord. Be sure that the electrical connection a...

6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. 4. On Ranges Equipped with a Storage Drawer: Remove the storage drawer. See the “Storage Drawer” ...

8 Electrical Connection - U.S.A. Only 1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover from range. 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. 4. Add stra...

10 4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw and ground-link section. The ground wire must be attached first. 5. Use ³⁄₈ " nut driver to connect the neutral (white) wire to the center terminal block post with...

11 1. Part of metal ground strap must be cut out and removed. 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Pull the wires through the strain relief on bottom of range. Allow eno...

12 2. Attach terminal lugs to line 2 (red), bare (green) ground, and line 1 (black) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to torque as shown in the following Bare Wire Torque ...

15 Moving the Range When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering. If removing the range is necessary for cleaning or maintenance: For power supply cord-connected ranges: 1. Slide range forward. 2. Unplug the power supply cord. 3. Complete cleaning o...

7 Hot Surface Indicator Light On ceramic glass models, the Hot Surface indicator light is located on the display panel.The Hot Surface indicator light will glow as long as any surface cooking area is too hot to touch, even after the surface cooking area is turned off. Coil Elements and Burner Bowls ...

8 Use flat-bottomed cookware for best cooking results and energy efficiency. The cookware should be about the same size as the cooking area outlined on the cooktop. Cookware should not extend more than 1 / 2 " (13 mm) outside the area. Home Canning Canning can be performed on a glass smoothtop c...

9 Sabbath Mode (on some models) For guidance on usage and a complete list of models with Sabbath mode, visit www.star-k.org.The Sabbath mode sets the oven to remain ON in a Bake setting until turned off. The Oven Control Lockout feature will be disabled during the Sabbath mode. After the Sabbath mod...

11 RANGE CARE Self-Cleaning Cycle (on some models) IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the Self-Cleaning cycle. Exposure to the fumes may result in death to certain birds. Always move birds to another closed and well-ventilated room.Do not block t...

12 General Cleaning IMPORTANT: Before cleaning, make sure all controls are OFF and the oven and cooktop are cool. Always follow label instructions on cleaning products. For additional information, you can visit the Frequently Asked Questions (FAQs) section of our website at www.amana.com . Soap, wat...

13 COIL ELEMENTS (on some models) Cleaning Method: ■ Damp cloth: Make sure control knobs are OFF and elements are cool. Do not clean or immerse in water. Soil will burn off when hot. BURNER BOWLS (on some models) Before removing or replacing coil elements and burner bowls, make sure they are cool an...

14 TROUBLESHOOTING First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in this manual and scan the code there with your mobile device, or visit http://amana.custhelp.com . Contact us by mail...

15 ACCESSORIES For accessories, you can visit our website at www.amana.com or call us at 1-800-843-0304 . Problem Possible Causes Solutions Oven cooking results not what expected Range is not level. Level the range. See the Installation Instructions. The temperature set was incorrect. Double-check t...

W10881062BSP PN W10881070 ® /™ © 2016. All rights reserved. 6/16 11/14 IF YOU NEED SERVICE: 1. Before contacting us to arrange service, please determine whether your product requires repair. Some questions can be addressed without service. Please take a few minutes to review the Troubleshooting or P...