Page 2 - RANGE SAFETY; WARNING
2 RANGE SAFETY Tip Over Hazard A child or adult can tip the range and be killed.Install anti-tip bracket to floor or wall per installation instructions.Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.Re-engage anti-tip bracket if range is moved.Do not operate range...
Page 3 - INSTALLATION REQUIREMENTS; Tools and Parts; Tools needed
3 INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Tape measure ■ Flat-blade screwdriver ■ Phillips screwdriver ■ Level ■ Hammer ■ Hand or electric drill ■ ...
Page 4 - Location Requirements; Product Dimensions
4 If connecting to a 3-wire system: ■ A certified 60245 or 60227 IEC 53 (minimum) supply cord set marked for use with ranges. The cord should be rated 300/300V minimum, 6 mm 2 for 220V or 10 mm 2 for 230V, that is marked for use with nominal 3.5 cm diameter connection opening and must end in ring te...
Page 5 - Cabinet Dimensions; Electrical Requirements; Electrical Connection
5 Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood...
Page 6 - INSTALLATION INSTRUCTIONS; Unpack Range; Install Anti-Tip Bracket
6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape, and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. On Ranges Equipped with a Storage Drawer: Remove the storage drawer. See the “Storage Drawer” se...
Page 8 - Power Supply Cord
8 Electrical Connection Power Supply Cord Direct Wire 1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover from range. 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal bl...
Page 9 - Electrical Connection Options
9 Style 2: Direct wire strain relief ■ Remove the knockout as needed for the flexible conduit connection. ■ Assemble an IEC Approved conduit connector in the opening. ■ Tighten strain relief screw against the flexible conduit. 5. Complete installation following instructions for your type of electric...
Page 12 - Complete Installation; Moving the Range
Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Check that the range is level. See the “Level Range” sectio...