Alpine TME-M580 - Manuals - manualsarea.com

Page 2 - Points to Observe for Safe Usage; WARNING

DO NOT DISASSEMBLE OR ALTER. Doing so may result in an accident, fire or electric shock. KEEP SMALL OBJECTS SUCH AS BATTERIES OUT OF THE REACH OF CHILDREN. Swallowing them may result in serious injury. If swallowed, consult a physician immediately. USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES....

Page 3 - USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY.; DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST.; HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS.; HALT USE IMMEDIATELY IF A PROBLEM APPEARS.; CAUTION

ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP METAL EDGE. Route the cables and wiring away from moving parts (like the seat rails) or sharp or pointed edges. This will preventcrimping and damage to the wiring. If wiring passes through a hole in metal, use a rubber grommet to preventt...

Page 4 - Operation; Screen Display ON/OFF; Adjust the volume level by pressing the DN or UP button.; Switching the source; Each press of the button will cycle through the modes as follows:; UP; AUX; WIDE

Page 4 Operation Screen Display ON/OFF 1. Press the PWR button.2. To turn off the POWER, press the PWR button again. Note:If properly connected, the monitors main POWER will turn off when the vehicle’signition switch is off. If the main power lamp illuminates in the STAND BY mode, thevehicle’s batte...

Page 5 - Reset the Monitor Settings; Adjust by pressing the DN or UP button.

Page 5 Operation Reset the Monitor Settings 1. Press and hold the PWR button for at least 1 second.2. Press the SEL button.3. Select the Navigation system by pressing the DN or UP button. : Standard - Navigation for all others (except Europe) : Europe - Navigation for Europe only If no key is presse...

Page 6 - In Case of Difficulty; * Replacement of the fluorescent tube is not covered under the

Page 6 Symptom Cause Solution No function or Car's ignition is off. Turn the ignition on. display. No fuse or blown fuse. Check the cause and replace the fuse. Incorrect connections. Check connection and remedy. Vehicle's battery is weak. Check the voltage of vehicle's battery. Unclear picture Fluor...

Page 7 - Installation

Page 7 Installation Caution:Do not install the monitor near the front passenger seat air bag system.<Mount it using the supplied bracket> 1. Assemble the supplied bracket and mount the monitor temporarily. Note: Always use the supplied bracket or equivalent. 2. Verify the installation location...

Page 8 - Connections; MONITOR; Specifications

Page 8 Connections CautionsMake connections correctly.Improper connections may cause a fire or operationfailure. 1 Ground lead (Black) Connect the lead to a good chassis ground on thevehicle. Make sure the connection is made to baremetal and is securely fastened using the sheet metalscrew provided. ...

Page 10 - NOT USED

Page 10 TME-M580 + Navigation Only 13 Pin Nav Cable to Alpine Navigation 3 Pin EXT (if running nav only) 8 Pin Din to Monitor Brain 8 Pin to Monitor 8 Pin Power Harness 1 6 5 10 POWER EX-2 EX-1 TD DISP. MIC/SW GPS ANT. 13 Pin Nav Cable (included with Alpine Navigation systems) Power Harness Color Co...