Page 2 - Contents
WLBARGO Manual PB 1 1. Product Introduction ...................................................................................................3 1.1 Package Contents ............................................................................................ 3 1.2 Features .............................
Page 3 - Ad va n c e d s e t t i n g / R o u t i n g Ta b l e / D y n a m i c R o u t i n g ( R I P )
WLBARGO Manual 2 3 2 3 2 3 <WAN setting (world wide web)>.....................................................30<WAN setting/ Dynamic DNS> ......................................................... 32 <WAN setting/Other setting> .........................................................
Page 4 - Wall Mount Kit; working with corega WLCBGMO or corega WLUSB2GO.; Product Introduction
2 3 2 3 WLBARGO Manual 2 3 Corega WLBARGO is a 54M wireless broadband Router with IEEE802.11g wireless access point standard. It supports TX-burst technology which can effectively improve the transmit speed. It also contains 5 dBi detachable antenna which can maximum transmit length up to 500m. More...
Page 5 - Hardware Introduction
WLBARGO Manual 4 5 4 5 4 5 1.3 Hardware Introduction 134 5 7 6 2 8 9 11 10 1. Reset Button Press this button it will reset to default setting 2. WLAN LED (Green)ON:Connected 3. Power LED (Green)Indicate power status 4.Status LED (Orange)Steady on: AbnormalBlink:ConnectedFlash:Firmware upgrade/Reboot...
Page 6 - Hardware Installation; Following the steps below to set up WLBARGO and the connection.; Installation Procedure; Product Installation
4 5 4 5 WLBARGO Manual 4 5 2.1 Hardware Installation Following the steps below to set up WLBARGO and the connection. (1) Insert the cable connector into the Network Adapter embeded in PC, and insert the other side into one of LAN ports (1~4) of the Router. (2) Insert the connect into the WAN port of...
Page 7 - PC Setting
WLBARGO Manual 6 7 6 7 6 7 3.1 TCP/IP Configuration The following steps and screenshots maybe dissimilar in different operat-ing systems. This manual takes Windows XP/2000, 95/98/ME, and Mac O/S as examples: 3.1.1 Windows XP O/S (1) Enter [Control Panel] -> click [Network Connection] -> right ...
Page 9 - and
WLBARGO Manual 8 9 8 9 (5) Click [DNS] tab, unselect [Register this connection’s address in DNS], and press [OK]. (6) Go back to [Internet Protocol TCP/IP] and press [OK].(7) Press [OK] to close [Local Area Connection Properties]. 3.1.2 Windows 2000 O/S (1) Go to [My Computer], and enter [Control Pa...
Page 13 - the PC is not shown this message, restart the PC manually.
WLBARGO Manual 12 13 12 13 (4) Click [Gateway] tab, remove all the gateways, and press [OK] to close the window. (5) Go to [Network] and press [OK] to close the page.(6) The [Restart the windows] screen will pop-up, press [OK] to restart the PC. If the PC is not shown this message, restart the PC ma...
Page 14 - Browser Configuration
12 13 WLBARGO Manual 12 13 3.2 Browser Configuration 3.2.1 Windows O/S The following examples are for Windows XP O/S, skip this chapter if you are using Windows 2000/98/ME. (1) Open Internet Explorer (IE 6.0), select [ Tools] menu and click [Internet Options]. If a [Dial-up Connection] window is pop...
Page 16 - Quick Network Configuration; Network Configuration
14 15 14 15 WLBARGO Manual 14 15 4.1 Quick Network Configuration Basic configuration is required before connection your computer to the inter-net via WLBARGO. The connection methods may be differed by your contract to the ISP. Please reconfirm your connection conditions with your ISP prior to config...
Page 19 - Fixed IP
WLBARGO Manual 18 19 18 19 (4) Within seconds, the result of the connection test will be appeared in the dialogue box to indicate the connection status. When [Connection ok] appears, click on [Close]. (5) Open the web browser (IE 6.0), and test with any website for testing the connection. * Note: if...
Page 24 - Establishing the Wireless Internet Connection
22 23 WLBARGO Manual 22 23 (5) Open the web browser (IE 6.0), and test with any website for testing the connection. *Note: If the connection to the website fails. Please make sure the data you entered are correct , or any mistake occured in the process of the installation, such as the LAN/WAN connec...
Page 25 - (3) Connection status will appear in the bottom right of the screen.
WLBARGO Manual 24 25 24 25 (2) Go [Control Panel] -> [Network connection] again ->Right click [ Wireless network connection] ,select [Available wireless network connection], choose one available network e.g. ) corega , and click [Connect]. (3) Connection status will appear in the bottom right ...
Page 27 - Wireless Security Configuration
WLBARGO Manual 26 27 26 27 26 27 To prevent from unlawful access to your network, you are recommended to perform wireless security setting. Type [192.168.1.1] in the browser’s address bar, press [Enter]. Enter the function menu, ad click on [802.11g/b Security set-ting] item. And select WEP or WPA s...
Page 28 - WPA Setting; cally according to the corresponding wireless network adapter.
26 27 26 27 WLBARGO Manual 26 27 5.2 WPA Setting WPA is encrypted by a periodic update, making it more difficult to be hacked. Home users and company users are recommended to use <WPA-PSK> and <WPA-EAP> respectively. <WPA-PSK> (1) Select [ WPA-PSK], [ WPA2-PSK] or [ WPA/WPA2-PSK(Rec...
Page 29 - staff before setting.
WLBARGO Manual 28 29 28 29 28 29 <WPA-EAP> (1) Select [ WPA2-EAP] or [ WPA/WPA2-EAP](Recommended). in the column of [Authentication] a. [ WPA2-EAP]: The 2nd generation encryption skill performs stricter protec- tion than before. Before selection, please check the function availability of your ...
Page 30 - Mode; Function Introduction
28 29 28 29 WLBARGO Manual 28 29 The chapter will briefly introduce all functions of this product, and spell them out. Log in the management program and the below interface will appear. 6.1 Features <Mode> Mode Select and switch to Router(wireless broadband router) or AP(Acess point) mode.*Not...
Page 32 - Type
30 31 WLBARGO Manual 30 31 B.For auto obtain IP (DHCP) : Type Press [MAC address clone] to obtain the Ethernet card's MAC address. Computer name Please refer to your ISP internet service information, add/edit [Computer name]. MTU value Maximum Transmission Unit.Please accept the deafault setting:150...
Page 33 - WAN IP address
WLBARGO Manual 32 33 32 33 C. For fixed IP WAN IP address Please refer to your ISP internet service information. Subnet maskDefault gatewayMTU Maximum Transmission Unit. Deafault setting :1500 Byte. DNS server When [Manual Setup] is enable, two DNS server addresses can be inserted: DNS1 and DNS2 Mult...
Page 37 - MAC address filter list Use MAC address filter to control network
WLBARGO Manual 36 37 36 37 <Wireless setting/802.11g/b security setting> This section contains WEP,WAP-PSK, WPA2-PSK, WPA-EAP and WPA2-EAP encryption setting, please refer to Chapter 5 to get detail information. <Wireless setting/Connection control> Wireless to wireless connection Configu...
Page 38 - Configuring firewall and no response to WAN Ping requests.
36 37 WLBARGO Manual 36 37 <Security setting> Configuring firewall and no response to WAN Ping requests. <Security setting/Connection control> This function can limit or control some certain networking services: (1) Enter the range of limited IP address.(2) Select one of limit/stop netwo...
Page 39 - be displayed in the table below.
WLBARGO Manual 38 39 38 39 <Security setting/filter list> This function can forbid users to access certain website on the Internet: (1)Enter the forbidden URL or keywords(2) Then click [save] to complete the configuration. All the forbidden data will be displayed in the table below. <Advanced...
Page 41 - All routing logs are displayed in the table.
WLBARGO Manual 40 41 40 41 <Advanced setting/Routing Table/Routing Table> All routing logs are displayed in the table. <Advanced setting/UPnP > Activating this function can detect the device or software of LAN, supporting UPnP. For example: online games supporting UPnP or Windows Messeng...
Page 43 - Time Setup; saves to select the file.
WLBARGO Manual 42 43 42 43 * Time Setup Select one of the time setup models. If user is in [Day light saving] region, please select [enable]. * Firmware update (1) Click [Browse] to open the data folder. Follow the route that the firmware saves to select the file. (2) After selection, click [Firmwar...
Page 44 - The activation processes are as follows:
42 43 WLBARGO Manual 42 43 The activation processes are as follows: (1) Select [Enable].(2) Indicate 1 ~ 9600 for parameters of port range. e.g. ) 8080 (Recommended keeping default values). (3) Click on [Save] after completing settings. e.g. ) Assume the port value is 8080, enter IP address as the t...
Page 45 - System log is displayed in the table.
WLBARGO Manual 44 45 44 45 44 45 44 45 44 45 <Status/Log Display/system log> System log is displayed in the table. <Status/Log Display/E-mail function> An E-mail address can be set below. Special incidents will be recorded and sent to the appointed E-mail address. After entering all info...
Page 46 - information of this product.; FAQ
44 45 44 45 44 45 WLBARGO Manual 44 45 44 45 When the installation fails or the connection doesn’t succeed, it’s recommend-ed to take the following actions.(1) Find your problem in the troubleshooting collection.(2) Search on our official website at http://www.corega-asia.com for the latest informati...
Page 47 - until that user exits the program.
WLBARGO Manual 46 47 46 47 Configuration to check your setting]. (8) Has all information provided by your ISP been entered correctly? (9) Are the settings of your web browser correct? Q2. Can not access the management programA: Please confirm the following settings.(1)Is the TCP/IP address correct?(Pl...
Page 48 - reset the product’s settings to default values.
46 47 WLBARGO Manual 46 47 <Windows XP/ 2000> (1) Click [Start] => [Programs] => [Command prompt].(2) Input [ipconfig] => [Enter].(3) Confirm IP address (which sould be 192.168.1.x). If the IP is incorrect, please enter 1-byte character as [ipconfig /renew] => Press [Enter]. <Windo...
Page 49 - Specifications
WLBARGO Manual 48 49 PB 48 48 49 48 49 PB 48 Compliance Stand-ard WLAN:IEEE802.11, IEEE802.11b, IEEE802.11gLAN:IEEE802.3, IEEE802.3u, IEEE802.3x Interface WAN:10/100Mbps x 1 Port (RJ-45, Auto MDI/MDI-X)LAN:10/100Mbps x 4 Ports (RJ-45, Auto MDI/MDI-X) Transmission speed IEEE802.11b: 11/5.5/2/1MbpsI...
Page 50 - Federal Communication Commission Interference Statement; that may cause undesired operation.; Appendix
WLBARGO Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a r...
Page 51 - About corega
WLBARGO Manual corega 可瑞加科技於 1996 年成立於日本新橫濱,致力於提供多元化的家用 網路產品:包括乙太網路交換器、無線區域網路系列產品、路由器、藍芽系列產品、以及與網路相關的產品應用及服務。 corega 目前已是日本專業 家用網路產品的暢銷品牌,並且於 2002 年 2 月於台北成立可瑞加科技,專 注於台灣市場推廣高品質的日系家用網路設備。 corega 以使用者的需求導 向為最重要的營運方針,多樣化的產品行銷以及通路服務營造 corega 為最 親切適用的家庭網路設備第一品牌! 竭誠感謝您購買 corega 可瑞加系列產品,期待本產品為您帶來更快速便捷 的連線體...