Allied Telesis AT-MC103LH - Manuals

Page 2 - Copyright

Copyright  1998, 1999 Allied Telesyn International, Corp. 960 Stewart Drive Suite B, Sunnyvale CA USA 94086 All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn International, Corp. Ethernet is a registered trademark of Xerox Corpor...

Page 3 - iii; Safety Warnings

iii Safety Warnings STANDARDS: This product meets the following standards RFI Emission EN55022 Class A ! 1 WARNING: In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. ! 2 Immunity EN50082-1 1997 WARNING: This product ...

Page 6 - Key Features; Note

2 Figure 4 AT-MC103LH (SC single mode connector) Key Features The media converters have the following key features: ❑ LEDs for unit and port status ❑ MDI/MDI-X Switch ❑ NML/LNK TST Switch ❑ 100Base-TX ports participate in auto-negotiation for 100 Mbps and half- or full-duplex modes ❑ MissingLink  p...

Page 7 - Installation Guide; LEDs

Installation Guide 3 LEDs The PWR LED in the upper right corner of the front panel lights when the media converter is receiving power. Status LEDs are located on the front panel next to each port and described in Table 1. Table 1 LEDs MDI/MDI-X Switch The MDI/MDI-X (Media Dependent Interface/Media D...

Page 9 - Package Contents; Warning

Installation Guide 5 Package Contents Make sure the media converter package contains the following items: ❑ AT-MC101XL, AT-MC102XL, AT-MC103XL, or AT-MC103LH Fast Ethernet Media Converter ❑ Four Protective Feet (for standalone use only) ❑ External AC-DC Power Adapter ❑ This Installation Guide Contac...

Page 12 - Configurations; Figure 9 Connection to Workstation and Switch; FAST ETHERNE; FAST ETHERNET SWITCH

8 Configurations Figure 9 shows a typical network configuration with a workstation connected to a switch. Figure 9 Connection to Workstation and Switch Figure 10 shows two media converters in a back-to-back configuration. Figure 10 AT-MC101XL Back-to-Back Configuration RS-232 TERMINAL POR T STATUS 1...

Page 13 - Troubleshooting; To troubleshoot your media converter, perform the following:; Technical Specifications; Table 2 lists the media converter technical specifications.; Table 2 Media Conver ter Technical Specifications

Installation Guide 9 Troubleshooting To troubleshoot your media converter, perform the following: 1. Set the unit in the Link Test mode. 2. End stations used with the media converter must operate in the same duplex mode (either both full-duplex or both half-duplex). 3. Verify that the twisted pair c...

Page 14 - Media

10 Recommended Cables and Cable Specifications Table 3 lists the IEEE 802.3u cabling specifications for the media converters. Refer to Table 3 for cabling recommendations. Note 1. Single-mode fiber transmitter is rated as a Class 1 laser.Note 2. Each Media Conv erter used inline within a single coll...

Page 15 - Technical Support and Service

Installation Guide 11 Technical Support and Service You can contact the reseller or distributor where you purchased your product for local assistance. If local support is unable to resolve the problem, Allied Telesyn offers technical support via fax, e-mail or telephone. Refer to Appendi xD, for tec...

Page 17 - Appendix A

13 Appendix A Electrical Safety and Installation Requirements STANDARDS: This product meets the following standards STANDARDS: This product meets the following standards ! 1 RFI Emission EN55022 Class A ! 2 WARNING: In a domestic environment this product may cause radio interference in which case th...

Page 23 - Appendix B

19 Appendix B AT-MC101XL, AT-MC102XL, AT-MC103XL, and AT-MC103LH Installation Guide Feedback Please tell us what additional information you would like to see discussed in this guide. If there are topics you would like information on that were not covered in this guide, please photocopy this page, an...

Page 25 - Appendix C; Technical Support Fax Order; Incident Summary; Detailed description (Please use separate sheet)

21 Appendix C Technical Support Fax Order Name _________________________________________________________________ Company ______________________________________________________________ Address _______________________________________________________________ City______________________ State/Province___...

Page 27 - Appendix D; Where To Find Us; For Technical Support or Service; Location; For Sales and Corporate Information

23 Appendix D Where To Find Us For Technical Support or Service Location Phone Fax AmericasUnited States, Canada, Mexico, Central America, South America 1 (800) 428-4835 1 (918) 628-3222 AsiaSingapore, Taiwan, Thailand, Malaysia, Indonesia, Korea, Philippines, China, India, Hong Kong (+65) 3815-612 ...