Allied Telesis AT-AR023 SYN - Manuals

Page 2 - Port Interface Card; Installation and Safety Guide

Port Interface Card Installation and Safety Guide AT-AR020 PRI E1/T1AT-AR021(S) BRI-S/TAT-AR021(U) BRI-U AT-AR022 ETHAT-AR023 SYNAT-AR024 ASYN4AT-AR026 4ETHAT-AR027 VoIP-FXS Download the complete document set fromwww.alliedtelesis.com/support/software

Page 4 - About this Guide; Compatible Switches and Routers

Installation and Safety Guide 3 About this Guide Port Interface Cards (PICs) are a cost effective and flexible mechanism for adding new or additional network interfaces to your switch or router. This Installation and Safety Guide describes how to install the following PICs: ■ AT-AR020 PRI E1/T1, a s...

Page 5 - Package Contents

4 Port Interface Card Package Contents The following items are included with each Port Interface Card (PIC). Contact your authorised Allied Telesis distributor or reseller if any items are damaged or missing. ■ two spring-loaded retaining thumbscrews ■ two jumpers (AT-AR020 PRI E1/TI and AT-AR021(S)...

Page 6 - Installing a PIC; Caution

Installation and Safety Guide 5 Installing a PIC This section describes the procedure for installing a PIC. You should also follow this procedure, in particular the safety procedures and warnings, when replacing or removing a PIC. Caution You cannot install PICs into an AT-AR040 NSM that has power a...

Page 8 - show system

Installation and Safety Guide 7 AT-AR026 4ETH PICs have user-configurable links that set features such as auto-negotiation, buffer size, and MAC address aging. For a detailed description of the links, see the Port Interface Card Hardware Reference . For more information on PIC jumpers and hardware c...

Page 9 - Setting the ISDN Territory; australia

8 Port Interface Card Setting the ISDN Territory Before you connect an AT-AR020 or AT-AR021 PIC to the ISDN network, check that the ISDN territory is set correctly for your region. 1. Log in to your switch or router. For more information, see the Installation and Safety Guide included with your swit...

Page 10 - Downloading VoIP Firmware; off

Installation and Safety Guide 9 Downloading VoIP Firmware If you have installed an AT-AR027 VoIP PIC, you now need to download and install the VoIP firmware onto your PIC. Before you begin, check that the PIC Error LED on the PIC is off , and that the PIC has been recognised by your switch or router...

Page 11 - bold

10 Port Interface Card 6. Load the protocol image onto the PIC. To load the protocol image, use the command: enable voip protocol={h323|sip} [engine={ engine }] The boot code loads the protocol onto all AT-AR027 PICs unless you specify an individual PIC (engine). The engine name is formed by concate...

Page 12 - Obtaining Documentation and Resources; Other resources

Installation and Safety Guide 11 Obtaining Documentation and Resources For more information, see: ■ the Installation and Safety Guide for your switch or router ■ the Port Interface Card Hardware Reference , which contains detailed information on PICs and their hardware features ■ the Network Service...

Page 13 - Telecommunications Interfaces; Warning; Save these instructions

12 Port Interface Card Telecommunications Interfaces Warning To reduce risk of fire, use only No.26 awg (0.4 mm) or larger telecommunications line cord if the cord supplied is not used with the apparatus. Important Safety Instructions When using your telephone equipment, basic safety precautions sho...