Allied Telesis AR770S - Manuals

AR700 Series Router 4 Models Covered By This Guide This Installation and Safety Guide includes information on these models: ■ AR750S ■ AR770S Documentation updates can be found at www.alliedtelesis.com/support/documentation/ Package Contents AR750S package contents These items are included with the ...

Installation and Safety Guide 5 AR770S package contents These items are included with the AR770S router: ■ One AR770S router ■ A set of AC power cords One of these is suitable for your region. If desired, you can return the extra cords to your authorised distributor or reseller. ■ One power cord ret...

AR700 Series Router 6 Before installing ■ Read the safety information “Safety” on page 20 . ■ Gather the tools and equipment you will need. To install an AR750S or AR770S in a rack ( Installing the router in a rack ) you will need: • the rack mount bracket kit included with your router • a Phillips ...

Installation and Safety Guide 7 Installing the router in a rack 1. Check the rack. Ensure that the rack is safely secured and that it will not tip over. Devices in a rack should be installed starting at the bottom, with the heavier devices near the bottom of the rack. Ensure the rack has sufficient ...

AR700 Series Router 8 Installing the router on a wall 1. Screw the brackets to the AR750S router. Screw a wall mount bracket to the outer screw holes on each side of the router using the shorter screws supplied (see figure below). 2. Screw the wall brackets to the wall with the brackets at the top a...

Installation and Safety Guide 9 Installing SFPs Warning Do not look into the optical ports of SFP cables or transceivers. Invisible laser radiation may be emitted from disconnected fibres or connectors. If you purchased optional SFPs for the AR770S, install them in the Ethernet SFP slots (leftmost)....

AR700 Series Router 10 Fit the power cord retaining clip to the AC power inlet on the router’s rear panel. Connect the provided power cord to the AC power inlet and clip it in place. Switch the router’s power switch to the ON position. The Power LED lights continuously and the System LED lights brie...

Installation and Safety Guide 11 1. Connect the PC to a router switch port. The PC can be connected directly, or through your LAN. To connect the PC directly to the router, use a straight-through Ethernet cable to connect an Ethernet card on the PC to any one of the router’s switch ports. To connect...

AR700 Series Router 12 3. Browse to the GUI. If you access the Internet through a proxy server, set your browser to bypass the proxy for 192.168.1.1. Point your web browser at 192.168.1.1. 4. Log in and set the password. At the log in prompt, enter the log in name and password. Passwords are case se...

Installation and Safety Guide 13 Configuring with the CLI Caution If another device on your network already uses the router’s default IP address, 192.168.1.1, do not connect the router to the network until you have changed the IP address of the router’s default VLAN by using the command line. 1. Ini...

AR700 Series Router 14 2. Log in and set the password. The login prompt appears on the terminal or PC. If the login prompt does not appear, press [Enter] two or three times. When the router boots for the first time it automatically creates an account with manager privileges. The account has the logi...

Installation and Safety Guide 15 5. Use the CLI to continue configuring the router. See the AR700 Series Router Software Reference for details about commands available for configuring the router (including a list of message definitions). To display a list of help topics, enter: help To display help ...

AR700 Series Router 16 Connecting Data Cables to the Router Connecting the router to your network: 1. Connecting to the LAN. If you have not already done so, use Ethernet patch cables to connect the devices on your private network (LAN) to the router’s switch ports. By default, all switch ports are ...

AR700 Series Router 18 LEDs on the AR770S LED State Function Status PWR Green The router is receiving power and is switched ON. Status SYS Off Normal operation. Amber Lit briefly during router start up, or when the router system is malfunctioning. Flashing The router fan has failed. Ethernet SFP 0.....

Installation and Safety Guide 19 Documentation and Tools CD-ROM The Documentation and Tools CD-ROM bundled with each router contains the complete Document Set for your router. The CD-ROM also includes tools for managing your router. The Document Set on the CD-ROM includes: ■ This Installation and Sa...

AR700 Series Router 20 Emission Compliance Statements STANDARDS : The AR700 Series routers meet the following standards: Safety WARNING: In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Category Approval Agency and ...

AR700 Series Router 22 Sicherheit WARNUNG: Bei Verwendung zu Hause kann dieses Produkt Funkstörungen hervorrufen. In diesem Fall müßte der Anwender angemessene Gegenmaßnahmen ergreifen. WARNUNG Laserprodukt der Klasse 1. WARNUNG Nicht direkt in den Strahl blicken. ACHTUNG: GEFÄHRLICHE SPANNUNG Das G...

Installation and Safety Guide 23 Lithium-Batterie - Sollte nur von einem geschulten qualifizierten Techniker ausgetauscht werden. VORSICHT : Explosionsgefahr bei unsachgemäßem Austausch der Batterie. Nur mit einer gleichen Batterie oder einem gleichwertigen Batterietyp nach Empfehlung des Hersteller...

AR700 Series Router 24 ELEKTRISK-OVERBELASTNING AF SPÆNDINGSKREDSLØBET Ved installation af produktet, bør der tages hensyn til den kumulative kapacitet der angives på navneskiltet, når udstyret forbindes med vekselstrømsledningen. ADVARSEL : MEKANISK OPSTILLING-Udstyret skal opstilles i stativet, på...

Installation and Safety Guide 25 OPGELET: De ventilatiegaten mogen niet worden gesperd en moeten de omgevingslucht ongehinderd toelaten voor afkoeling. BEDRIJFSTEMPERATUUR: AR750S, AR770S: De omgevingstemperatuur voor dit produkt mag niet meer bedragen dan 50 graden Celsius. ELEKTRISCH: OVERBELASTIN...

Installation and Safety Guide 27 Turvallisuus VAROITUS: Kotiolosuhteissa tämä laite voi aiheuttaa radioaaltojen häiröitä, missä tapauksessa laitteen käyttäjän on mahdollisesti ryhdyttävä tarpeellisiin toimenpiteisiin. VAROITUS Luokan 1 Lasertuote. VAROITUS Älä katso säteeseen. SÄHKÖÖN LIITTYVIÄ HUOM...

AR700 Series Router 28 Norme di Sicurezza AVVERTENZA: in ambiente domestico questo prodotto potrebbe causare radio interferenza. In questo caso potrebbe richiedersi all’utente di prendere gli adeguati provvedimenti. AVVERTENZA Prodotto laser di Classe 1. AVERTENZA Non fissare il raggio con gli occhi...

Installation and Safety Guide 29 Batteria al litio - Va sostituita solo da un tecnico specializzato e qualificato. ATTENZIONE: l'errata sostituzione della batteria può causare pericolo di esplosioni. Sostituire solamente con lo stesso tipo o con uno equivalente raccomandato dal produttore. Eliminare...

AR700 Series Router 30 FORSIKTIG : MEKANISK LASTNING Installering av utstyret på hyllen må utføres på en slik måte at ingen farlige situasjoner oppstår som en følge av ujevn lastning. Litiumbatteri — Må kun byttes ut av en faglig kvalifisert tekniker. FORSIKTIG : Eksplosjonsfare hvis batteriet feili...

Installation and Safety Guide 31 TEMPERATURA DE FUNCIONAMENTO: AR750S, AR770S: Este produto foi projetado para uma temperatura ambiente máxima de 50 graus centígrados. ELÉTRICO - SOBRECARGA DA REDE DE CORRENTE ALTERNADA (AC) Antes de instalar o produto, verifique o efeito cumulativo da conexão de di...

Installation and Safety Guide 33 Säkerhet VARNING: Denna produkt kan ge upphov till radiostörningar i hemmet, vilket kan tvinga användaren till att vidtaga erforderliga åtgärder. VARNING! Laserprodukt av klass 1. VARNING! Laserstrålning när enheten är öppen. TILLKÄNNAGIVANDEN BETRÄFFANDE ELEKTRICITE...

AR700 Series Router 34 Connection to mains voltage supply This product is supplied with a power cord that incorporates a moulded plug and has been approved for use. It must only be used with the power cord supplied. For continued protection against the risk of fire and shock hazard, replace fuses on...

Installation and Safety Guide 35 Connection to ISDN network Ports for the connection of other apparatus The following interfaces normally operate at SELV (Safe Extra Low Voltage) levels: ■ Asynchronous (console) ports ■ Ethernet ports ■ G703 ports ■ Synchronous ports Note SELV is a secondary circuit...

AR700 Series Router 36 US Federal Communications Commission (FCC) This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules for the United States. A label is located on the underside of the base unit containing the FCC registration number. You must, upon request, prov...

Installation and Safety Guide 37 Canadian Department of Communications The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equi...