Allied Telesis 86222-21 - Manuals

Allied Telesis 86222-21 – Manual in PDF format online.

Manuals:

Manual

Manual Allied Telesis 86222-21

Summary

Page 2 - Patch Release Note; TimeToLive

2 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T Features in 86222-21 Patch 86222-21 includes all issues resolved and enhancements released in previous patches for Software Release 2.2.2, and the following enhancements: Locally generated ICMP messages, that were pas...

Page 3 - Base Software Release File

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 3 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T In the ADD SWITCH L3FILTER command, the EPORT parameter incorrectly accepted the value 62-63 as multicast and broadcast ports 63-64. This issue has been resolv...

Page 4 - If a port on a Rapier 48 or Rapier 48

4 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T A fatal error sometimes occurred if a TCP session originating on the public side of the firewall sent packets before the session was established with the host on the private side of the firewall. This issue has been r...

Page 7 - Patch file details for Patch 86222-19 are listed in Table 3:; Network affecting: No

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 7 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T Existing IGMP groups were not deleted when IGMP was disabled globally or on the associated interface. This gave the groups very high timeout values. This issue...

Page 8 - is the filter number. Filter numbers are displayed in the

8 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T STP always transmits untagged packets. If a port does not belong to a VLAN as an untagged port, then the port must belong to one VLAN as a tagged port. In this case, STP should transmit VLAN tagged packets out of the ...

Page 9 - Patch file details for Patch 86222-18 are listed in Table 4:

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 9 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T When a file upload was interrupted, the file being uploaded was not unlocked. The file could not be deleted without restarting the router. This issue has been ...

Page 12 - Static ARPs can now be added to tagged vlans.

12 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T The TickTimer ran one percent slower than it should have. This issue has been resolved. Static ARPs can now be added to tagged vlans. When an IP flow table contained the IP flow structure for a spoofed packet, the SH...

Page 13 - Patch file details for Patch 86222-13 are listed in Table 8.

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 13 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T The SHOW IP ROUTE FILTER command output displayed counters for 'passes' and 'include' that were the same. This issue has been resolved. Counters now increment...

Page 16 - Patch file details for Patch 86222-11 are listed in Table 10.

16 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T The timeout value for ICMP session entries in the firewall can now be adjusted via the OTHERTIMEOUT parameter of the SET FIRE POLICY command. Note: if the value for OTHERTIMEOUT is set to more than 10 minutes the tim...

Page 17 - ENABLE SWI STPFORWARD

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 17 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T When a switch port was forced to half duplex mode and the link partner was forced to full duplex mode, it was possible for the switch to enter a state where i...

Page 18 - Patch file details for Patch 86222-08 are listed in Table 13.

18 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T The switch now delays sending link traps immediately after a restart to give the link to the trap host time to come up. A similar change has been made for the cold start trap. After a 10s delay, all interfaces which ...

Page 20 - MD5 Authentication now works correctly with RIP packets.

20 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T A watchdog timout occurred when the router received an HTTP message with an over-length header. Normal HTTP requests would also occasionally cause watchdog timeouts. These issues have been resolved. The OSPF route fi...

Page 22 - Patch file details for Patch 86222-06 are listed in Table 15.

22 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T If PPPoE AC services were not deleted in the same order they were added, the DELETE command would return an “operation successful” message but the service would still appear in the output of the SHOW PPP PPPOE comman...

Page 24 - Active TCP Opens

24 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T When a VLAN was created and then destroyed on the G6 or G6F, the VTABLE was corrupted. This has been fixed. DHCP failed to send request messages when it was in a rebinding or renewing state. This issue has been resol...

Page 26 - Patch file details for Patch 86222-01 are listed in Table 18.

26 Patch Release Note Patch 86222-21 for Software Release 2.2.2 C613-10319-00 REV T Features in 86222-01 Patch file details for Patch 86222-01 are listed in Table 18. Patch 86222-01 includes the following enhancement for Software Release 2.2.2: The DHCP server identified the wrong port numbers for i...

Page 27 - Availability; licence or password is not required to use a patch.

Patch 86222-21 For Rapier Switches and AR800 Series Modular Switching Routers 27 Patch 86222-21 for Software Release 2.2.2C613-10319-00 REV T Availability Patches can be downloaded from the Software Updates area of the Allied Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html ....