Page 3 - Table of
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT © Copyright 2010, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 9002062 1 ...
Page 4 - Introduction; Model Identification
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9002062 2 Introduction Model Identification Information in this manual is applicable to these models: 18 NX18BVPA6NX18BVPA7NX18BVQA6 NX18BVQA7NX18BVXA6NX18BVXA7 NX18BVXM7SX18BVPA7SX18BVQA7 SX18BVXA7SX18BVXM7 30 NX30BVPA6NX30BVPA7NX3...
Page 5 - Safety Information; Explanation of Safety Messages; DANGER
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 3 9002062 Safety Information Explanation of Safety Messages Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These precautions are inte...
Page 7 - Safety Decals; WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 5 9002062 IMPORTANT: Ensure that the recommended clearances for inspection and maintenance are provided. Never allow the inspection and maintenance space to be blocked. Safety Decals Safety decals appear at crucia...
Page 8 - Operator Safety
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 9002062 6 Operator Safety To ensure the safety of machine operators, the following maintenance checks must be performed daily: 1. Prior to operating the machine, verify that all warning signs are present and legib...
Page 9 - Specifications and Dimensions
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 7 9002062 Specifications and Dimensions General Specifications Model 18 30 33 40 Overall Dimensions Overall width 660 mm (26 in.) 780 mm (30.7 in.) 780 mm (30.7 in.) 780 mm (30.7 in.) Overall height 1038 mm (40.9 in.) 1202 m (47.3 i...
Page 15 - Installation; Dimensional Clearances; Machine Foundation; CAUTION
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 13 9002062 Installation Dimensional Clearances Table 1 shows recommended minimum clearances on all sides of the washer-extractor. Machine Foundation Thoroughness of detail must be stressed with all foundation work to ensure a stable...
Page 17 - Removing the Transport Block; IMPORTANT: Do NOT lift motor by the pulley.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 15 9002062 Removing the Transport Block To prevent damage during transportation, machine has been equipped with a transport block. To remove, proceed as follows: 1. Place machine on level ground. 2. Remove service panel...
Page 19 - Operation; Control Panel
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 17 9002062 Operation Control Panel Figure 9 CHM482R CHM488R 1 Cycle 1 7 Cycle 7 2 Cycle 2 8 Cycle 8 3 Cycle 3 9 Down Edit/Change keypad 4 Cycle 4 10 Up Edit/Change keypad 5 Cycle 5 11 Start/Enter keypad 6 Cycle 6 12 Display CHM482R ...
Page 20 - Operating Instructions
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002062 18 Operating Instructions 1. Turn on main power source (circuit breaker). 2. Pull the door handle towards you to open the door. Some models may have a door handle with a button that must be pressed. 3. Load to capa...
Page 21 - When applicable
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 19 9002062 7. Add liquid and/or powder supplies to supply dispenser. Refer to Figure 12 . a. Add detergent to compartment 1. b. Add softener to compartment 3. 8. Add coins to machine. As each coin is added, the vend counts...
Page 22 - Disposal of Unit
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9002062 20 Disposal of Unit This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). This symbol on the product or on its packaging indicates that this product shal...