Alliance HCN020KCF- Manuals

Safety Information F8208401 4 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT IMPORTANT: Ensure that the recommended clearances for inspection and maintenance are provided. Never allow the inspection and maintenance space to be blocked. Safety Decals Safety decals appear at cruci...

Safety Information 5 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operator Safety To ensure the safety of machine operators, the following maintenance checks must be performed daily: 1. Prior to operating the machine, verify that all warning signs are present and legi...

F8208401 6 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction Model Identification Information in this manual is applicable to these models: Model 20 POUND HCD020GD2 HCD020JD2 HCD020LD2HCL020GD2HCL020GN2 HCL020HDF HCL020HN2HCL020KD2 HCL020LD2 HCN020GC2 HCN020GD2 HCN020G...

Introduction 9 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Nameplate Location The nameplate is located at the rear of the machine and inside door. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Fi...

11 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation Operating Instructions 1. Turn on main power source (circuit breaker). 2. Turn handle clockwise to open. Refer to Figure 3 . NOTE: For 125 capacity models through 1/31/11, press the Unlock/Stop keypad, push the...

Operation F8208401 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 7. Add liquid and/or powder supplies to supply dispenser. Refer to Figure 6 . a. Detergent: • Liquid - Compartment 1 (prewash) + Compartment 3 • Powder - Compartment 1 (prewash) + Compartment 2 b. Bleach: • Liq...

13 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance IMPORTANT: Replace all panels that are removed to perform service and maintenance procedures. Do not operate the machine with missing guards or with broken or missing parts. Do not bypass any safety devices. ...

Maintenance F8208401 14 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Weekly 1. Check the machine for leaks. a. Start an unloaded cycle to fill the machine. b. Verify that door and door gasket do not leak. c. Verify that the drain valve is operating and that the drain system is...

Maintenance 15 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT c. For flat-pulley drive systems, verify allowable distance of belt from edge of pulley. Refer to Table 1 below. d. For F and variable-speed models only , verify that V-belts are properly tensioned by applyin...

Maintenance F8208401 16 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 7. Use compressed air to clean lint from motor.8. Clean interior of machine, both basket and shell, by wiping with a water-soaked sponge or cloth. 9. Use compressed air to clean all electrical components of m...

Maintenance 17 F8208401 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Care of Stainless Steel • Remove dirt and grease with detergent and water. Thoroughly rinse and dry after washing. • Avoid contact with dissimilar metals to prevent galvanic corrosion when salty or acidic sol...