Allen-Bradley SAFE 4 - Manuals

Operation Manual GuardShield Safe 4 2. Introduction GuardShield Safe 4 safety light curtains are active optoelectronic protective equipment AOPE type 4 with object detection capability of 14 mm or 30 mm. GuardShield Safe 4 has built-in fully redundant self-monitoring circuitry and complies to annex ...

GuardShield Safe 4 Operation Manual 3.2. Applications restrictions GuardShield Safe 4 is not designed and approved for any application in explosive EX or radioactive areas. 3.3. Application conditions The safe application of the light curtain system GuardShield Safe 4 needs certain precautions: 1. T...

Operation Manual GuardShield Safe 4 As accessories two types of mirrors are available, with different mounting plates and sizes. Detailed information is available from ROCKWELL AUTOMATION. 4. Principles of operation The transmitter sends coded infrared light pulses to the receiver, which evaluates t...

GuardShield Safe 4 Operation Manual 5. Installation 5.1. Regulations and standards The compliance with the fundamental health & safety requirements as detailed in the EU Machinery Directive EC/98/37 and control reliability according to OSHA 29 CFR 1910.212, ANSI B11.19 and ANSI B11.20 has to be ...

Operation Manual GuardShield Safe 4 This distance, referred to as the safety distance, must be properly calculated prior to determining the safety light curtain protective height and mounting the light curtains on the machine. Failure to properly calculate this safety distance may result in operator...

GuardShield Safe 4 Operation Manual 5.1.5. Distance to reflective surfaces Reflective surfaces may cause reflections within the transmitter and receiver aperture angle, i.e. an interruption of the protective field would not be recognized ( Figure 7 ). Figure 7: Distance to reflective surfaces Should refle...

Operation Manual GuardShield Safe 4 11 M6 x 40 M4 x 16 29 M4 x 12 M6 x 40 60 445L-AF6140Standard mounting brackets • For side mounting • Adjustable by ± 4° 445L-AF6144Vertical mounting brackets (optional) • For mounting in the vertical axis of the light curtain • Adjustable by ± 4° 445L-AF6141 180° ...

GuardShield Safe 4 Operation Manual 5.2.3. Adjustment Procedure without ILAS 1. Mount the transmitter and the receiver with the adjustable mounting brackets. Make sure that the longitudinal axis of both are oriented parallel. A spirit level might help to find the correct position. 2. Take care that t...

Operation Manual GuardShield Safe 4 Figure 11: Adjustment with ILAS 5.2.6. Testing the protection field After Installation and Alignment of the GuardShield Safe 4 safety light curtain, the protection field has to be tested with the test rod for the corresponding resolution (14 or 30 mm) according Figu...

GuardShield Safe 4 Operation Manual Figure 15: Wiring of the connecting cables of the M12/5 Pin connector Transmitter and receiver are supplied with M12/5 pin connectors. The wiring of such connecting plugs is given in Figure 14 and Figure 15 . 5.3.2. Test input to transmitter Normally the test inpu...

Operation Manual GuardShield Safe 4 15 Important information: Safety devices for connection of GuardShield Safe 4 must be built with PNP logic. The outputs will be periodically controlled for short-circuit and cross-fault detection. The output voltage at the solid-state outputs is dependant on the p...

GuardShield Safe 4 Operation Manual 18 12 0 4. 72 4 24 0 9. 4 4 9 12 0 4. 7 2 4 24 0 9. 4 4 9 12 0 4. 7 2 4 36 0 14 .17 3 12 0 4. 72 4 1 20 4. 72 4 p a s s iv e a c ti v e a c ti v e a c ti v e p a s s iv e 1.177 29.9 4 0. 1 5 7 10 51 41 .3 78 40 1.575 40 1.575 a c ti v e a c ti v e p a s s iv e 1.1...

Operation Manual GuardShield Safe 4 19 57 35 M16 M12 145 ILAS Emitter ILAS target 25 A ILAS target ILAS Emitter 3 B Start of protective field 30 40 Pin 1 Pin 7 4 3 2 Cross section withconnector pinning Transmitter Receiver Detailmounting groove Figure 23: Dimensional drawing, cross Section with Pin-...

GuardShield Safe 4 Operation Manual 20 8. Selection of a safety light curtain 8.1. Check list In consideration of following points the selection of a proper GuardShield Safe 4 safety light curtain will be simplified: 1. Regulations Look up carefully the actual regulations and codes applicable to the ...

Operation Manual GuardShield Safe 4 21 Table 4: 30 mm resolution with ILAS Catalog No. Protective Total length B Response time t R Max. range Resolution Weight per pair height A (mm) (ms) (m) (mm) (kg) (mm) 445L-P4S0120YD 120 290 7.8 6 30 1.0 445L-P4S0240YD 240 410 10.5 6 30 1.4 445L-P4S0360YD 360 5...

GuardShield Safe 4 Operation Manual 22 Table 7 ROCKWELL AUTOMATION Description Part No . 445L-AF6140 Standard mounting kit (4 pieces) 445L-AF6141 Adjustable mounting kit 445L-AF6142 Shock mount kit 445L-AF6144 Mounting kit for POC AND Sick FGS adapter (4 pieces) 445L-AF6150 Optical Interface (incl. ...

Operation Manual GuardShield Safe 4 23 11. Technical Data Table 8 Description Value Remarks Protective heights 120 mm to 1920mm 120mm increments Operating range 0 ... 9 m Resolution 14 mm 0 ...6m Resolution 30 mm Object detection capability 14 mm (Resolution) 30 mm Power supply U sp 24 VDC ± 20 % PE...

Please contact us for T echnical Assistance: In the U.S.: 1-440-646-5800 Outside U.S.: 001-440-646-5800 On line: http://www.ab.com/safety P N - 29484 ��������� ��������������� �������������� ��� ����� ����������������� �� �� � 10000026005 Ver 01 April 2009