Page 2 - IMPORTANT SAFETY INSTRUCTIONS; Do not use damaged appliances. If you are in any doubt, consult an
IMPORTANT SAFETY INSTRUCTIONS Before switching on your Bar Cooler for the first time, read the information in this Users’ Manual carefully. Keep this booklet in a safe place for future reference. If you ever sell you appliance, hand this manual to the new owner. The manufacturer does not accept resp...
Page 3 - Do not damage the refrigerant circuit.; BEFORE USING FOR THE FIRST TIME; , do not position this appliance with its
above 30 ° C. The refrigerator meets the operating conditions according to the standard EN 441-4 in climate class 4. A 10A fuse is fitted. Never replace with a fuse rated higher than this. · Do not allow children to play with the appliance or to sit on it or to hang onto the door. · Make sure there ...
Page 4 - OPERATION; ELECTRONIC THERMOSTAT
OPERATION · Place the shelves firmly on their supports. Check that the refrigerator is functioning properly before installing and filling it. An optional light switch is inside the unit. · Never put warm or hot food directly into the Bar Cooler. There are several types of controller/thermostat for d...
Page 5 - To manually activate “Defrost” cycle:; MECHANICAL THERMOSTAT
To manually activate “Defrost” cycle: · Press the button and hold it for 6 seconds until a “beep” can be heard. · The indicator light will now illuminate under the “Defrost” symbol and the fridge is into a “Defrost” cycle. · “Defrost” will run for 20 minutes and then automatically revert to normal o...
Page 6 - IMPORTANT; below 4; DEFROSTING / MAINTENANCE; Switch the power on again via the thermostat.; CLEANING; Wash the inner compartment with warm water and neutral detergent.
IMPORTANT · The fridge will go through a normal periodical defrosting cycle and a manual defrosting operation is only required in most extreme cases. It is better to avoid if not necessary. · While in the “Defrost” mode, the fridge cooling power is reduced as the compressor is not working. The autom...
Page 7 - REPLACING LAMPS; Unplug the power plug.; DISPOSAL OF PACKAGING; used again after adequate recycling.
· Do not allow the control panel, cables or plug to get wet. · Never use corrosive detergents, wire brushes or abrasive scourers to clean your Bar Cooler. Also, never use metal or sharp implements to remove debris / dirt. · Dry all surface thoroughly. · To ensure a trouble-free operation, the conden...
