AEG Washer 74950A- Manuals

Detergent dispenser drawer Compartment for detergent used for pre- wash . The prewash detergent is added at the be - ginning of the wash programme. Compartment for powder or liquid detergent used for main wash . Compartment for liquid additives (fabric soft - ener, starch). Compartment for stain rem...

7 START/PAUSE button ( START/PAUSE ) 8 DELAY START button ( DELAY START ) 9 Display Symbols on the control panel : = Handwash= Child Lock Display 9.1 9.2 9.4 9.5 9.6 9.7 9.8 9.3 9.9 9.1 - Temperature indicator and COLD symbol 9.2 - Spin Speed indicator, RINSE HOLD , NIGHT CYCLE - symbols 9.3 - Progr...

• Delay start – The selected delay (20 hours max) set by means of the relevant button appears on the display for about 3 seconds (for example ’), then the duration of the previously selected programme is displayed. – The DELAY START symbol will appear on the display. – The delay time value decreases...

Child safety lock This device permits you to leave the appliance unattended and not to worry that children might be injured by or cause damage to the appliance. This function remains able also when the washing machine is not working. To enable (or disable) this option press simultaneously for about ...

2. If required, pour fabric softener into the compartment marked (the amount used must not exceed the MAX mark in the drawer). Close the drawer gently. Select the required programme by means of programme selector dial (1) You can choose the right programme for any type of laundry following the descr...

Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3) When the required programme has been selected, your appliance automatically proposes the maximum spin speed provided for that programme. Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a ...

This option is recommended for heavily soiled laundry. STAIN option Select this option to treat heavily soiled or stained laundry with stain remover (extended main wash with time optimized stain action phase). The relevant symbol will appear on the display. This option is not available with a temper...

If an incorrect option is selected, the yellow pilot light of the button 7 blinks 3 times and the message Err is displayed for a few seconds. Select the DELAY START (button 8) Before you start the programme , if you wish to delay the start, press the button re - peatedly, to select the desired delay...

Opening the door after the programme has started First set the machine to pause by pressing the button 7 . • If the DOOR symbol disappears, the door can be opened; • If the DOOR symbol doesn’t go off, it means that the machine is already heating, that the water level is above the bottom edge of the ...

Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Fabrics Load - Type of Laundry Options Detergent Com - partment ECONOMY COTTONS ECONOMY 60° Main wash - Rinses - Long spin at the maximum spin speed Max. load 8 kg White and fast coloured cotton . This programme can be selecte...

Rub particularly soiled areas with a special detergent or detergent paste. Treat curtains with special care. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the washing programme charts. General rules: • Cotton, linen: drum full but not too tightly packe...

Ink: depending on the type of ink, moisten the fabric first with acetone 1) , then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Detergents a...

When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop le...

7. Screw the hose back to the machine and make sure the connection is tight. 8. Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: 1. close the water tap and unscrew the water inlet hose from the tap; 2. pla...

During machine operation it is possible that the yellow pilot light of button 8 blinks, one of the following alarm codes appears on the display and at the same time some acoustic signals sound every 20 seconds to indicate that the machine is not working: • : problem with the water supply • : problem...

The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, on the inlet water temperature and on the ambient temperature. Installation instructions Installation Unpacking All transit bolts and packing must be removed ...

6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 7. Connect the water inlet hose as described under the paragraph «Water inlet». Positioning and levelling Install the machine on a flat hard floor. M...

Water-stop device The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to nat - ural ageing of the hose. This fault is shown by a red sector in the window «A» . Should this occur, turn the water tap off and refer...

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domest...

Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help...