AEG SKS71200F0- Manuals

1. Press the Mode button until the Hol-iday indicator flashes. 2. Press the OK button to confirm. 3. The Holiday indicator goes off. The function switches off by se-lecting a different fridge set tem-perature. 2.9 Door open alarm An acoustic alarm will sound if the dooris left open for a few minutes...

3.4 Positioning the sliding box The sliding box can be placed at differ-ent heights.Do make these adjustments proceed asfollow: 1. lift the shelf with the sliding box up-wards and out of the holders in thedoor 2. remove the retaining bracket out ofthe guide under the shelf 3. Reverse the above opera...

5. CARE AND CLEANING CAUTION! Unplug the appliance before car-rying out any maintenance oper-ation. This appliance contains hydrocar-bons in its cooling unit; mainte-nance and recharging musttherefore only be carried out byauthorized technicians. 5.1 Periodic cleaning The equipment has to be cleaned...

6. WHAT TO DO IF… WARNING! Before troubleshooting, discon-nect the mains plug from themains socket.Only a qualified electrician orcompetent person must do thetroubleshooting that is not in thismanual. Problem Possible cause Solution The appliance isnoisy The appliance is not sup-ported properly Chec...

Problem Possible cause Solution The compressordoes not start im-mediately afterpressing the COOL-MATIC switch, or af-ter changing thetemperature. This is normal, no errorhas occurred. The compressor starts aftera period of time. Water flows on therear plate of the re-frigerator. During the automatic...

7. INSTALLATION 7.1 Positioning WARNING! If you are discarding an old appli-ance that has a lock or catch onthe door, you must ensure that itis made unusable to preventyoung children being trapped in-side. The appliance shall have theplug accessible after installation. Install this appliance at a lo...

13 amp ASTA approved (BS 1362) fusemust be used. WARNING! A cut off plug inserted into a 13amp socket is a serious safety(shock) hazard. Ensure that it isdisposed of safely. 7.3 Ventilation requirements 5 cm min. 200 cm 2 min. 200 cm 2 The airflow behind the appliance mustbe sufficient. 8. NOISES Th...

9. TECHNICAL DATA Dimension of the recess Height 1225 mm Width 560 mm Depth 550 mm Voltage 230-240 V Frequency 50 Hz The technical information are situated inthe rating plate on the internal left sideof the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with thesym...

• It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. • Adequate air circulation should be around the appliance, lacking this leads to overheat- ing. To achieve sufficient ventilation follow the instructions relevant to install...

The COOLMATIC indicator is shown. The COOLMATIC function shuts off automatically after approximately 6 hours. To switch off the function before its automatic end:1. Press the Mode button until the COOLMATIC indicator flashes. 2. Press the OK button to confirm. 3. The COOLMATIC indicator goes off. Th...

Do not use detergents or abrasive powders, as these will damage the finish. If “dEMo” appears on the Display, the appliance is in demonstration mode: refer to “WHAT TO DO IF...” paragraph. DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelv...

HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.• If the ambient temperature is high and the Temperature Regulator is set to low tempera- ture and the appliance is fully loaded, the compressor may run continuously, ca...

Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at th...

WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible ca...

Problem Possible cause Solution Products prevent that water flows into the water collector. Make sure that products do not touch the rear plate. The temperature in the appliance is too low/high. The temperature regulator is not set correctly. Set a higher/lower temperature. The door is not closed co...

TECHNICAL DATA Dimension of the recess Height 1225 mm Width 560 mm Depth 550 mm Voltage 230 - 240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Positioning WARNING! If you are discarding a...

Ventilation requirements The airflow behind the appliance must be suffi- cient. NOISES There are some sounds during normal running (compressor, refrigerant circulation). BRRR! HISSS! CLICK! BLUBB! CRACK! SSSRRR! OK CLICK! CLICK! 50 mm min. 200 cm 2 min. 200 cm 2 Noises 17

CRACK! CRACK! ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is d...