AEG SKS5821LAF- Manuals

Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION

CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................

Page 4 - SAFETY INSTRUCTIONS; Installation

• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging and the ...

Page 5 - OPERATION

• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the compressor or the condenser. They are hot. 2.4 Internal light • The type of lamp used for this appliance is not suitable for household room illumination 2.5 Care and cleanin...

Page 6 - DAILY USE; Positioning the door; HINTS AND TIPS; Normal operating sounds

CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore red...

Page 7 - CARE AND CLEANING

• A faint click noise from the temperature regulator when the compressor switches on or off. 5.2 Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. 5.3 Hints for fresh food refrigeration To obtain the best performance:• do not store warm food...

Page 8 - TROUBLESHOOTING

1. Clean the inside and accessories with lukewarm water and some neutral soap. 2. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. 3. Rinse and dry thoroughly. 4. If accessible, clean the condenser and the compressor at the back of the appliance with a bru...

Page 10 - Replacing the lamp

Problem Possible cause Solution The temperature in the ap-pliance is too low/too high. The temperature regulator isnot set correctly. Set a higher/lower tempera-ture. The door is not closed cor-rectly. Refer to "Closing the door". The food products' tempera-ture is too high. Let the food pro...

Page 11 - Closing the door; INSTALLATION; Location; Ventilation requirements

7. Open the door. Make sure that the light comes on. 7.3 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to assembly instructions. 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. 8. INSTALLATION WARNING! Refer to Safety ...

Page 12 - TECHNICAL DATA; Technical data

WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in the mains lead are coloured in accordance with the following code: A B C D E • A - green and yellow: Earth • C - brown: Live • D - blue: Neutral As the colours ...

Page 13 - ENVIRONMENTAL CONCERNS

10. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household...