AEG SKS5821EAF- Manuals

Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION

CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................

Page 4 - SAFETY INSTRUCTIONS; Installation

• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging and the ...

Page 5 - OPERATION

• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the compressor or the condenser. They are hot. 2.4 Internal light • The type of lamp used for this appliance is not suitable for household room illumination 2.5 Care and cleanin...

Page 6 - DAILY USE; Positioning the door

CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore red...

Page 9 - TROUBLESHOOTING

7. TROUBLESHOOTING WARNING! Refer to Safety chapters. 7.1 What to do if... Problem Possible cause Solution The appliance does not op-erate. The appliance is switchedoff. Switch on the appliance. The mains plug is not con-nected to the mains socketcorrectly. Connect the mains plug tothe mains socket ...

Page 10 - Replacing the lamp

Problem Possible cause Solution Water flows on the floor. The melting water outlet isnot connected to the evapo-rative tray above the com-pressor. Attach the melting wateroutlet to the evaporativetray. The temperature in the ap-pliance is too low/too high. The temperature regulator isnot set correct...

Page 11 - Closing the door; INSTALLATION; Location; Ventilation requirements

3. Replace the used lamp with a new lamp of the same power and shape, specifically designed for household appliances. The maximum power is shown on the lamp cover. 4. Install the lamp cover. 5. Tighten the screw to the lamp cover. 6. Connect the plug to the mains socket. 7. Open the door. Make sure ...

Page 12 - Electrical Connection; TECHNICAL DATA; Technical data

8.4 Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in ...

Page 13 - ENVIRONMENTAL CONCERNS

10. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household...