AEG SKE68811AS- Manuals

Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION

CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................

Page 4 - SAFETY INSTRUCTIONS; Installation

• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging and the ...

Page 5 - OPERATION

• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the compressor or the condenser. They are hot. 2.4 Internal light • The type of lamp used for this appliance is not suitable for household room illumination 2.5 Care and cleanin...

Page 6 - DAILY USE; Positioning the door

CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore red...

Page 8 - TROUBLESHOOTING

CAUTION! Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. 6.3 Periodic cleaning CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet. CAUTION! Take care of not to damage the cooling system. CAUTION! When moving the cab...

Page 10 - Replacing the lamp

Problem Possible cause Solution The temperature in the ap-pliance is too low/too high. The temperature regulator isnot set correctly. Set a higher/lower tempera-ture. The door is not closed cor-rectly. Refer to "Closing the door". The food products' tempera-ture is too high. Let the food pro...

Page 11 - Closing the door; INSTALLATION; Location; Ventilation requirements

3. Reassemble the lamp cover. 4. Connect the plug to the mains socket. 5. Open the door. Make sure that the light comes on. 7.3 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to assembly instructions. 3. If necessary, replace the defective door gaskets. Contact t...

Page 12 - Electrical Connection; TECHNICAL DATA; Technical data

8.4 Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in ...

Page 13 - ENVIRONMENTAL CONCERNS

10. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household...