AEG SK48840-2I- Manuals

Installation Installation Location The appliance should be set up in a well ventilated, dry room.Energy use is affected by the ambient temperature.The appliance should therefore– not be exposed to direct sunlight;– not be installed next to radiators, cookers or other sources of heat;– only be instal...

30 Description of the appliance View of the appliance ➀ ➁ ➁ ➆ ➂ ➃ ➄ ➇ ➅ ➀ Butter and cheese compartment ➁ Door storage compartment ➂ Bottle shelf ➃ Vegetable drawer ➄ Shelves ➅ Temperature regulator and interior lighting ➆ Freezer compartment (for storage and freezing) ➇ Rating plate Prior to Initia...

31 Starting up and temperature regulation Important! Only use the appliance when built–in! The temperature regulator is in therefrigerator compartment on theupper right. It is also the ON/OFF-switch. Position „0“ = Refrigeration off Position „1“ = Warmest interior tem- perature Position „6“ = Coldes...

Recommended settings: Examples: 3. If you want a higher or lower temperature, turn the temperature regu-lator to a warmer or cooler setting respectively. Important! High ambient temperatures (e.g. on hot summer days) and a cold set-ting on the temperature regulator (position"5" to "6"...

33 Interior Accessories Storage Shelves/Storage Racks Depending on the model, your appliance is equipped with either glassstorage shelves or storage racks. The glass shelf above the fruit andvegetable compartment must always remain in this position so thatfruit and vegetables stay fresh longer.The r...

35 Preparation of ice cubes • Thawed foods which have not been processed further (cooked into meals) may not under any circumstances be frozen a second time. • Caution! Do not touch frozen food with wet hands. Your hands could stick to the food and cause skin abrasions. ☞ 1. All foods must be packed...

36 Defrosting The fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor isrunning, and defrosts when the compressor is off.The water from the thawing frost is collected in the drain channel onthe rear of the fridge, feed through the drain hole into the colle...

Cleaning and Care 4. Remove the stopper from the melt-water outlet and place a bowl under-neath it to catch the meltwater. Attention! After defrosting, replace the plug in the condensation waterdrain. Tip: You can speed up the defrosting process by placing a pan with warmwater in the freezer compart...

38 Energy Saving Tips ☞ 1. Remove frozen food and the food from the refrigerator. Wrap frozenfood in several layers of newspaper. Store it in a cool place, well cov-ered. 2. Defrost the freezer compartment prior to cleaning (see “Defrosting”section). 3. Remove the mains plug or switch off or disconn...

39 What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault that you can recti-fy yourself using the following instructions. Do not perform any otherwork on the appliance if the following information does not provideassistance in your specific case. Important! Repa...

40 What to do if... Symptom Possible Cause Remedy Heavy build up of frost,possibly also on the doorseal. Door seal is not air tight(possibly after reversingthe door). Carefully warm the leakingsections of the door sealwith a hair dryer (on acool setting). At the sametime shape the warmeddoor seal by...

41 Customer Service If you cannot find the remedy for a malfunction in these operatinginstructions, please contact your dealer or our customer servicedepartment. Addresses and telephone numbers are listed in the accom-panying booklet "Guarantee Conditions/Customer Service Locations".Selectiv...

43 Technical terminology • Refrigerant Liquids that can be used to a generate a cooling effect are known asrefrigerants. They have a relatively low boiling-point, indeed so low,that the warmth from the food stored in the fridge or freezer cancause the refrigerant to boil and vaporise. • Refrigerant ...