Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. • Do not store explosive substances such as aerosol cans with a flammable propellant...
Page 7 - Storage of frozen food
accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand- new product, then dried thoroughly. CAUTION! Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. 4.2 Positioning the door shelves To perm...
Page 8 - HINTS AND TIPS
In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical data chart under "Rising time", the defrosted food must be consumed quickly or cooked immediately and then re- frozen (after cooling). 4.6 Tha...
Page 9 - CARE AND CLEANING; General warnings
and garlic must not be kept in the refrigerator if not packed. • Butter and cheese: place in a special airtight container or wrap in an aluminium foil or a polythene bag to exclude as much air as possible. • Bottles: close with a cap and place on the door bottle shelf, or (if available) on the bottl...
Page 10 - TROUBLESHOOTING
CAUTION! When moving the cabinet, lift it by the front edge to avoid scratching the floor. The equipment has to be cleaned regularly: 1. Clean the inside and accessories with lukewarm water and some neutral soap. 2. Regularly check the door seals and wipe clean to ensure they are clean and free from...
Page 12 - Replacing the lamp
Problem Possible cause Solution Water flows on the rearplate of the refrigerator. During the automatic de-frosting process, frostmelts on the rear plate. This is correct. Water flows inside the refrig-erator. Food products prevent thewater to flow into the wa-ter collector. Make sure that food produ...
Page 13 - INSTALLATION; Location; Electrical Connection
3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. 8. INSTALLATION 8.1 Location Refer to the assembly instructions for the installation. To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlig...
Page 14 - Ventilation requirements; NOISES; BRRR; OK
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp ( E ) is secure over the ...
Page 15 - TECHNICAL DATA; Technical data; ENVIRONMENTAL CONCERNS
BRRR! BRRR! HISSS! HISSS! BLUBB! BLUBB! CRACK! CRACK! 10. TECHNICAL DATA 10.1 Technical data Dimensions of the recess Height mm 1780 Width mm 560 Depth mm 550 Rising time Hours 20 Voltage Volts 230 - 240 Frequency Hz 50 The technical information is situated in the rating plate, on the external or in...