Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. CONTROL PANEL............................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging and the ...
Page 5 - CONTROL PANEL
• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the compressor or the condenser. They are hot. 2.4 Internal light • The type of lamp used for this appliance is not suitable for household room illumination 2.5 Care and cleanin...
Page 6 - DAILY USE
key repeatedly until the required temperature is selected. The setting will be fixed. Selection is progressive, varying from +2°C to +8°C. Coldest setting: +2°C. Warmest setting: +8°C Most suitable setting: ECO mode (+3 to +4°C). Choose the setting keeping in mind that the temperature inside the app...
Page 7 - DYNAMICAIR; CARE AND CLEANING; Cleaning the interior
Position the food so that air can circulate freely around it.Keep the food on all shelves no closer than 20 mm from the rear wall and 15 mm from the door. 4.2 DYNAMICAIR The refrigerator compartment is equipped with a device that allows rapid cooling of food and keeps a more uniform temperature in t...
Page 8 - Periods of non-operation; TROUBLESHOOTING
5.4 Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Clean the appliance and all accessories. 4. Leave the door/doors open to prevent unpleasant smells. 6. TROUBLESH...
Page 9 - Replacing the lamp
Problem Possible cause Solution Water flows inside the re-frigerator. The water outlet is clog-ged. Clean the water outlet. Food products prevent wa-ter from flowing into thewater collector. Make sure that food productsdo not touch the rear plate. Water flows on the floor. The melting water outlet i...
Page 10 - INSTALLATION; Positioning; Electrical connection; TECHNICAL DATA
7. INSTALLATION WARNING! Refer to Safety chapters. 7.1 Positioning This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climateclass Ambient temperature SN +10°C to + 32°C N +16...