Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging and the ...
Page 5 - OPERATION
• Do not store flammable gas and liquid in the appliance. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the compressor or the condenser. They are hot. • Do not remove or touch items from the freezer compartment if your hand...
Page 6 - DAILY USE; Freezing fresh food; Storage of frozen food
If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperature, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energ...
Page 7 - CARE AND CLEANING; Cleaning the interior
5. CARE AND CLEANING WARNING! Refer to Safety chapters. 5.1 Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand- new product, then dried thorou...
Page 8 - Periods of non-operation; TROUBLESHOOTING
A certain amount of frost will always form on the freezer shelves and around the top compartment.Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. 1. Switch off the appliance, or pull out the electrical plug from the wall socket. 2. Remove any stored food, wrap it in seve...
Page 9 - Replacing the lamp
Problem Possible cause Solution Water flows inside the re-frigerator. The water outlet is clog-ged. Clean the water outlet. Food products prevent wa-ter from flowing into thewater collector. Make sure that food productsdo not touch the rear plate. Water flows on the floor. The melting water outlet i...
Page 10 - INSTALLATION; Positioning; Electrical connection
Use LED bulbs (E14 base) only. The maximum power is shown on the lamp unit. CAUTION! Disconnect the plug from the mains socket. 1. Pull the left side of the lamp cover with your fingers to unlock it. Remove the cover by pulling it towards yourself. 1 2 1 2. Replace the bulb with one of the same powe...