AEG PE8038-M/UK- Manuals

AEG PE8038-M/UK– User Manual in PDF format online.

Manuals:

User Manual

User Manual AEG PE8038-M/UK

Summary

Page 2 - DESCRIPTION OF THE ESPRESSO MACHINE; Coffee pressing tool

2 1. DESCRIPTION OF THE ESPRESSO MACHINE 1. Locking nut of filter holder 2. Steam/water pipe 3. Coffee pressing tool 4. Grinder button 5. Coffee measuring device 6. Adjusting knob for grinding 7. Container of coffee beans 8. Water reservoir 9. Drip tray 10. Brita filter 11. Measuring spoon for groun...

Page 3 - TOUCH KEYS; Water temperature indicator; TOUCH KEYS: Instructions of use

3 2. DESCRIPTION OF THE CONTROL PANEL: TOUCH KEYS 1. Water temperature indicator 2. ON/stand-by indicator 3. Coffee indicator 4. Water indicator 5. Steam indicator 6. Spotlight indicator 7. LEDs of coffee measures (strong coffee, weak coffee, 2 cups of strong coffee, 2 cups of weak coffee) 8. No-wat...

Page 4 - SAFETY INSTRUCTIONS; This machine must be used only by grown-up people.

4 3. SAFETY INSTRUCTIONS Using this machine is very easy. However, please read this instruction manual carefully and thoroughly before installing and operating this machine for the first time, so that any wrong operation can be avoided, the best and safest performance can be ensured, and environment...

Page 5 - CE; This machine complies with the directive BT 73/23

5 FOR INSTALLATION AND SERVICING − This machine must be installed and connected to the mains by a SKILLFUL ENGINEER. Make sure that the machine is DISCONNECTED from the power supply before any servicing operation. − After unpacking the machine make sure that the product has not suffered any damage a...

Page 6 - INSTRUCTIONS FOR THE FIRST USE OF THE MACHINE; FILLING UP THE WATER RESERVOIR; Press the unlocking levers

6 4. INSTRUCTIONS FOR THE FIRST USE OF THE MACHINE FILLING UP THE WATER RESERVOIR − Press the unlocking levers available under the drip tray and pull the machine as it is shown in the figure. − Extract the espresso machine out of the cabinet sliding on the special slides.

Page 8 - FILLING UP THE CONTAINER OF COFFEE BEANS

8 − Insert the machine into the cabinet pushing slightly until “CLIK!” can be heard: this is the signal that the machine has been locked. FILLING UP THE CONTAINER OF COFFEE BEANS − Press the unlocking levers available under the drip tray and pull the machine as it is shown in the figure. − Extract t...

Page 9 - SIGNALLING WATER MISSING IN RESERVOIR

9 − Pour approximately 200 g of coffee beans into the container availabe on the right side of the machine − Insert the machine into the cabinet pushing slightly until “CLIK!” can be heard: this is the signal that the machine has been locked. SIGNALLING WATER MISSING IN RESERVOIR ?? This machine is e...

Page 10 - PRELIMINARY STARTING: FIRST USE

10 PRELIMINARY STARTING: FIRST USE − After filling up the water reservoir, open the steam/water cock as it is shown in the figure. − Switch the espresso machine on by keeping the on-off/stand-by button pressed until the red LED stops flashing and is kept on. This indicator will signal the operating ...

Page 11 - RESETTING STANDARD VALUES; pressing both the on/off and hot-water buttons at the same time.

11 − After the water has flowed out (if necessary, repeat the draining operation several times), close the knob again. − As soon as the heating LED goes out, the machine has reached the right temperature and it is ready to make coffee. Only the on-off indicator is kept on. RESETTING STANDARD VALUES ...

Page 12 - each cup of coffee. Then the measures of ground coffee will not vary.; CAUTION –; ADJUSTING THE GROUND COFFEE; The success of a good espresso depends on this grinding level very

12 − A faint flashing of all the LEDs will signal that the factory values have been reset. N.B.: The standard values only concern the quantity of water required for each cup of coffee. Then the measures of ground coffee will not vary. CAUTION – ADJUSTING THE GROUND COFFEE − This machine is calibrate...

Page 15 - USING COFFEE BEANS

15 6. DRAWER (OPTIONAL) − This machine can also be provided with an optional well-equipped drawer mod. PES 8036-m , with front panel of stainless steel. This drawer has a lot of useful compartments: - a large compartment for cups and saucers - a basin for coffee grounds - a compartment for all acces...

Page 19 - eliminate the used pod.; HOW TO PREPARE AN EXCELLENT ESPRESSO; preparing a good espresso.; Useful advice; : coffee is a hygroscopic element, that is its quality and

19 − This machine is also prearranged to operate with paper pods, that is throwaway portions of roasted coffee (for only one cup of coffee). − Carry out the same operations like in the case of ground coffee; after coffee has been poured into the cup, remove the filter holder from the locking nut and...

Page 21 - HEATING LIQUIDS; will stop generating steam.

21 − Close the steam/water knob again. 9. STEAM HEATING LIQUIDS − Press the steam button once. Both the LEDs of steam and water temperature will be ON. Wait until both these LEDs go out. Pressing the steam button again will stop generating steam. − Pressing the steam button again will check whether ...

Page 22 - when preparing milk for cappuccino, shake the milk

22 − Place a pot with the liquid to be heated under the steam nozzle and turn the steam knob in anticlockwise direction. − Wait until the liquid warms up and then close the steam knob. − Attention: when preparing milk for cappuccino, shake the milk jug a little to improve the result. − Caution: neve...

Page 23 - PROGRAMMING THE QUANTITY OF GROUND COFFEE; This espresso machine has already been calibrated in factory to

23 10. PROGRAMMING THE QUANTITY OF GROUND COFFEE − This espresso machine has already been calibrated in factory to dispense the ideal measure of ground coffee for one cup of espresso. − However this quantity of ground coffee can be increased or reduced, then the selected measure is stored. The progr...

Page 25 - coffee measure will be stored automatically.; PROGRAMMING THE QUANTITY OF HOT WATER; programming mode (during this phase the water LED will blink).

25 − Once obtained the desired quantity of coffee press the button again and this coffee measure will be stored automatically. 12. PROGRAMMING THE QUANTITY OF HOT WATER − Place a pot under the steam/water nozzle and turn the steam/water knob anticlockwise. − Keep the water button pressed for approxi...

Page 26 - ITALIAN CAPPUCCINO; Some cocoa powder can also be dusted on the milk froth.; VIENNESE CAPPUCCINO; This variation is the result of the age-old Austrian tradition.

26 − Release the button when the water starts flowing out; then, once obtained the desired quantity of water press the button again and this measure will be stored automatically. − Then close the steam/water knob again. 13. RECIPES ITALIAN CAPPUCCINO This is a normal espresso with steam-heated milk ...

Page 27 - COLD ESPRESSO SHAKE; Serve in a tumbler or flûte.; IRISH COFFE; a further pinch of cinnamon, and blend together.; CAPPUCCINO ICE-CREAM

27 COLD ESPRESSO SHAKE Frothy and extremely refreshing, this drink is delicious on hot days. Prepare an espresso, add sugar and pour into a shaker with large ice cubes. Shake for few seconds. Serve in a tumbler or flûte. IRISH COFFE Energy-giving and invigorating drink. Warm a long glass and mix eig...

Page 28 - DRIP TRAY; relevant grille can be washed in a dishwasher.; FILTER – FILTER-HOLDER – LOCKING NUT; and filter holder in dishwasher every month.

28 DRIP TRAY − Remove the drip tray from the machine as it is shown in the figures above. − Make sure that the drip tray is periodically drained to prevent any liquid from seeping out and dirtying/damaging the underlying furniture. Drip tray and relevant grille can be washed in a dishwasher. FILTER ...

Page 30 - Fix the power cord onto the left

30 COMPONENTS FOR INSTALLING THE MACHINE This espresso machine will be installed into cabinets with height of 380 mm and width ranging from 560 mm to 568 mm. The machine is equipped with the following components for the installation: 1. 1 fixing base 2. 13 self-threading screws 3.9X19 3. 4 screws M4...

Page 32 - INSTALLING THE MACHINE WITHOUT DRAWER

32 INSTALLING THE MACHINE WITHOUT DRAWER − Lay the fixing base of the machine equipment on the shelf of the cabinet. − Insert the side plates for compensating for any space. The width of the compartment housing the espresso machine depends on the thickness of the cabinet’s sides. Four side plates (t...

Page 34 - INSTALLING THE ALIGNING BAR; When this espresso machine is; COMPONENTS FOR INSTALLING THE (OPTIONAL) DRAWER

34 INSTALLING THE ALIGNING BAR − When this espresso machine is assembled in a composition of electric household appliances, it could be installed beside a oven 10 mm higher. Align the assembly fixing the proper bar under the frontal panel with the four screws M4x16, as it is shown in the figure. COM...

Page 39 - TECHNICAL SPECIFICATIONS

39 17. TECHNICAL SPECIFICATIONS As regards the general dimensions of the machine, please see the fig. D − Width 594 mm − Depth 260 mm − Height 378 mm − Capacity of water reservoir 2.5 l − Net weight 17 kg − Gross weight 19 kg − Supply voltage 230 V − Rated power 1150 W − Power absorbed by the heatin...

Page 40 - FUSES

40 FUSES F1: Fuse Ø 5 x 20 mm - Vn = 250 V - In=10 A F2: Fuse Ø 5 x 20 mm – Vn = 250 V – In = 0.5 A

Page 41 - DECLARATION OF GUARANTEE TERMS; SERVICE & SPARE PARTS; Your telephone number; CUSTOMER CARE; Customer Care Department

41 18. DECLARATION OF GUARANTEE TERMS SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. F...