AEG LF8584M8O - Manuals

• The appliance maximum load is 8.0 kg. Do not exceed the maximum load of each program (refer to the “Programs” chapter). • The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 10 bar (1.0 MPa). • The ventilation opening in the base ...

than 0°C or where it is exposed to the weather. • The floor area on which the appliance is to be installed must be flat, stable, heat resistant and clean. • Make sure that there is air circulation between the appliance and the floor. • Do not install the appliance directly above a floor drain. • Adj...

2.5 Internal lighting WARNING! Risk of injury. • Visible LED radiation, do not look directly into the beam. • To replace the internal lighting, contact the Authorised Service Centre. 2.6 Service • To repair the appliance contact the Authorised Service Centre. Use original spare parts only. • Please ...

garment to the removing odours and wrinkles action. 3.2 Appliance overview 1 2 3 10 6 7 8 4 11 9 12 13 5 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Internal light 6 Rating plate 7 Drain pump filter 8 Feet for levelling the appliance 9 Drain hose 10 Inlet hose connection 11 Mains...

5. Carefully put the appliance down on its rear side. 6. Put the front polystyrene packaging element on the floor under the appliance. Make sure not to damage the hoses. 7. Remove the polystyrene protection from the bottom. 1 2 8. Pull up the appliance in vertical position. 9. Remove the power suppl...

The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm - min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5...

6. CONTROL PANEL 6.1 Control panel description 3s Finish In Re m ote Star t O n/O ff Stain s/ Prewa sh Tim e S ave E x tra Rin s e Plu s Steam Temperature Spin Sports Home Special 4 5 3 2 7 8 6 15 14 12 11 10 13 1 9 The options are not selectable with all washing programs. Check the compatibility be...

You must drain the water to unlock the door. Touch the Start / Pause button: the appliance performs only the draining phase. • No Spin . Set this option to deactivate all spin phases. The display shows theindicator . The appliance performs the only draining phase of the selected washing program. Set...

display shows the text Hr for 2 seconds, 12 (thousands and hundreds) for 2 seconds and 76 (tens and units). 4. To exit this mode, press any button or switch the appliance off by means of theOn/Off button. If the procedure does not work (due to timeout or wrong keys combination), switch the appliance...

DO NOT set this mode with the following type of items: • Items that are not suitable for tumble drying. • Items with label "Dry clean only". Do not use any detergent! The Steam programs do not remove particularly intense odour and do not perform any hygienic cycle. After the steam treatment ...

Program Universal powder 1) Liquid Uni‐ versal Liquid for coloureds Delicates woollens Special Synthetics ▲ ▲ ▲ -- -- Delicates -- -- -- ▲ ▲ Wool -- -- -- ▲ ▲ 20min 3kg -- ▲ ▲ -- -- Bed l inen XL -- -- -- ▲ ▲ Hygiene ▲ ▲ -- -- ▲ 1) At temperature higher than 60 °C the use of powder detergent is reco...

11.6 Wi-Fi Always On The Wi-Fi Always On function is available in the App.This function keeps the appliance connected to the network even when the appliance is turned off.The indicator goes on and off intermittently (1 second on , 5 seconds off). It is possible to turn the appliance on by pressing t...

12.3 Filling the detergent and additives - Compartment for detergent pods (Max 2 pods). When using detergent tab‐ lets, make sure that the Pods® option is activated. - Compartment for prewash phase an soak program (powder detergent only). - Compartment for washing phase (powder detergent only). Make...

c) Put the tablets in the compartment . Make sure that the Pods® option is activated. 4. Pour fabric softener in the compartment . 5. Close the detergent dispenser. 12.4 Setting a program 1. Turn the program dial to select the desired washing program. The related program indicator comes on. The indi...

3. Set the program again. 12.7 The ProSense load detection The program duration in the display is referred to a medium/high load. After setting a washing program, the icon lights up on the display if the program supports it. After touching the Start / Pause button, the ProSense starts the laundry lo...

2. Change the options. The given information in the display changes accordingly. 3. Touch the Start / Pause button again. The washing program continues. 12.10 Cancelling a running program 1. Press the On/Off button to cancel the program and to deactivate the appliance. 2. Press the On/Off button aga...

indicator of the running phase flashes. • The drum still turns at regular intervals to prevent the creases in the laundry. • The door stays locked. • You must drain the water to open the door: 1. If necessary, touch the Spin button to decrease the spin speed proposed by the appliance. 2. Touch the S...

• Do not wash laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, shoelaces, ribbons, etc. ). • Empty pockets and unfold the items. 13.2 Stubborn stains For some stains, water and detergent is not sufficient.We recommend that...

• Loading the appliance to the maximum capacity indicated for each programs helps to reduce energy and water consumption. • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a lower temperature. • Set the maximum possible spin speed for the sel...

CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Do not clean the metal surfaces with chlorine-based detergent. 14.4 Descaling If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. Regularly examine the d...

program Machine Clean is also downloadable through the APP. 14.8 Cleaning the detergent dispenser To prevent possible deposits of dried detergent, clotted fabric softener, formation of mould in the detergent dispenser, once in a while carry out the following cleaning procedure: 1. Open the detergent...

as indicated in the picture. Close it till "click" sound. CAUTION! Press the bottom cover as indicated in the picture. Make sure that it is closed properly. CLICK 9. Reassembly the drawer as follows: a. Place the bottom cover and press till "click" sound. b. Place the top cover and p...

1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the program to drain the water. 14.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet ...

Problem Possible solution Too much foam in the drum during the wash‐ ing cycle. • Reduce the quantity of detergent or the number of tablets or single-dose detergents. • Too much detergent or unsuitable detergent has been used. Reduce detergent quantity and/or use a correct detergent. After the washi...

5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 16. QUICK GUIDE 16.1 Daily use + - 1 2 3 3 3 3 3 3 3 3 4 3 3 • Connect the mains plug to the mains socket. • Open the water tap. • Push the On/Off button to turn the appliance on (1). • Turn the program dial to set ...

Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aeg.com/au FOR SERVICE or to find the address of your nearest au‐ thorised service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL [email protected] For the ...