AEG L77484AFL- Manuals

Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Water supply 1) Cold water Maximum load Cotton 8 kg Spin speed Maximum 1400 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 3. PRODUCT DESCRIPTION 1 2 3 8 9 5 6 7 4 10 11 12 1 Worktop 2 Detergent dispens...

4. ACCESSORIES 1 2 3 4 1 Spanner To remove the transit bolts. 2 Plastic caps To close the holes on the rear sideof the cabinet after the removal ofthe transit bolts. 3 Anti-flood inlet hose To prevent possible leakage 4 Plastic hose guide To connect the drain hose on theedge of a sink. 5. CONTROL PA...

• After 5 minutes from the end of the washing programme. Refer to 'At theend of programme'. 5.2 Programme knob 2 Turn this knob to set a programme. Therelated programme indicator comes on. 5.3 Display 3 A B C D The display shows: A • The maximum temperature of the programme. B • The default spin spe...

Spin phase is off. 'Rinse Hold' function ison. 5.10 Temperature button 10 Press button 10 to change the default temperature. - - = cold water 5.11 Acoustic signals function You can hear the acoustic signals when:• You activate the appliance.• You deactivate the appliance.• You press the buttons.• Th...

ProgrammeTemperature Type of loadmax. weight ofload Cycledescription Functions Extra Leise95° - Cold White and colouredcotton with normalsoil.max. 8 kg Stop with water inthe drumRinsesLong spin FLECKEN 1) EXTRA SPÜLENZEIT SPAREN 2) Pflegeleicht60° - Cold Synthetic or mixedfabric items withnormal lev...

ProgrammeTemperature Type of loadmax. weight ofload Cycledescription Functions Gardinen40° - Cold Set this programmeto wash curtains. Itadds automaticallythe prewash phaseto clean the dustfrom the curtains.Do not put the de-tergent into the pre-wash compartment.max. 2 kg PrewashWashRinsesShort spin ...

7) Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, the ‘Baumwolle Eco 60 °C’ and ‘Baumwolle Eco 40 °C’ arerespectively the “standard 60 °C cotton programme” and the “standard 40 °C cottonprogramme”. They are the most efficient programmes in terms of co...

1) At the end of spin phase. Model Off Mode (W) Left On Mode (W) L 77484 AFL 0.05 0.05 8. BEFORE FIRST USE 1. To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispens-er. 2. Put a small quantity of detergent inthe main wash compartment of the deterge...

11. FILLING THE DETERGENT AND ADDITIVES The detergent compartment for the prewash phase and thesoak programme.Add the detergent for prewash and soak before the start of theprogramme. The detergent compartment for the washing phase.If you use a liquid detergent, put it immediately before you startthe...

3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed inthe flap. – Do not set the prewash phase.– Do not set the de...

2. Press button 1 again to activate the appliance. Now, you can set anew washing programme. The appliance does not drain thewater. 12.3 Change a function You can change only some functions be-fore they operate. 1. Press button 4 . The indicator flashes. 2. Change the function set. 12.4 Set the delay...

The washing programme iscompleted, but there is water in thedrum: – The drum turns regularly to prevent the creases in the laundry. – The door stays locked.– You must drain the water to open the door. To drain the water: 1. If necessary, decrease the spinspeed. 2. Press the Start/Pause button 4 . Th...

chines. In areas where the water hard-ness is soft it is not necessary to use awater softener.To know the water hardness in your area,contact your local water authority.Obey the instructions that you find onthe packaging of the products.Equivalent scales measure the waterhardness: • German degrees (...

15.4 Door seal Regularly examine the seal and removeall objects from the inner part. 15.5 Drum Regularly examine the drum to preventlimescale and rust particles.Only use special products to remove rustparticles from the drum.To do this: • Clean the drum with special product for stainless steel. • St...

15.7 Drain pump Regularly examine the drainpump and make sure that it isclean. Clean the pump if:• The appliance does not drain the wa- ter. • The drum cannot turn.• The appliance makes an unusual noise because of the blockage of the drainpump. • The display shows an alarm code be- cause of the prob...

7. Remove fluff and objects from thepump. 8. Make sure that the impeller of thepump can turn. If this does not oc-cur, contact the service centre. 1 2 9. Clean the filter under the water tapand put it back in the pump into thespecial guides. 10. Make sure that you tighten correctlythe filter to prev...

4. Remove the inlet hose behind theappliance. 5. Clean the filter in the valve with astiff brush or a towel. 45° 20° 6. Install again the inlet hose. Makesure that the couplings are tight toprevent leakages. 7. Open the water tap. 15.9 Emergency drain Because of a malfunction, the appliancecannot dr...

• - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on. WARNING! Deactivate the appliance beforeyou do the checks. Problem Possible cause Possible solution The appliancedoes not fill withwater. The water tap is closed. Open...

Problem Possible cause Possible solution The filter of the drainpump is blocked. Clean the filter of the drainpump. Refer to 'Care and clean-ing'. Balance problems withthe laundry load. Adjust manually the items in thetub and start the spin phaseagain. The programmedoes not start. The mains plug is ...

Problem Possible cause Possible solution You did not remove thestubborn stains beforeyou wash the laundry. Use special products to removethe stubborn stains. Incorrect temperaturewas set. Make sure that you set the cor-rect temperature. Too much laundry load. Decrease the laundry load. After the che...

• Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom the couplings. Do not use an extension hose ifthe inlet hose is too short. Con-tact the service centre for the re-placement of the inlet hose. Water-stop device A The inlet hose has a...

• On the edge of a sink.• Make sure that the plastic guide can- not move when the appliance drains.Attach the guide to the water tap orthe wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into adrain pipe at a height of not less than60 cm and not more than 100 cm. Theend o...

18. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle wasteof electrical and electronic appliances. Do not disposeappliances marked with the symbol with the household waste. ...