AEG L71060SLCS- Manuals

5. CONTROL PANEL 1 2 3 4 5 6 7 8 9 10 1 On/Off button ( Zap/Vyp ) 2 Programme knob 3 Display 4 Start Pause button ( Start/Pauza ) 5 Delay start button ( Odlažený Start ) 6 Time saving button ( Úspora Č asu ) 7 Extra rinse button ( Extra Máchání ) 8 Stain button ( Skvrny ) 9 Spin reduction button ( O...

C • The display symbols. 2) Symbols Description Washing phase Rinse phases Spin phase Child lock You cannot open the appliance door when the symbol ison.You cannot open the appliance door when the symbolflashes. Wait for some minutes before you open the door.You can open the door only when the symbo...

6. PROGRAMMES ProgrammeTemperature Type of loadmax. weight of load Cycledescription Functions Bavlna Cottons95° - Cold White and colouredcotton with normalsoil.max. 6 kg WashRinsesLong spin SPIN REDUC-TIONRINSE HOLDSTAIN 1) EXTRA RINSETIME SAVE 2) Bavlna + P ř ed- pírka Cottons + Pre-wash95° - Cold ...

ProgrammeTemperature Type of loadmax. weight of load Cycledescription Functions Bavlna Eco 8) 60° - 40° White and fast col-oured cotton withnormal soil.max. 6 kg WashRinsesLong spin SPIN REDUC-TIONRINSE HOLDSTAINEXTRA RINSETIME SAVE 2) 1) The STAIN function is not available with a temperature lower ...

Pro- grammes Load (kg) Energy consump- tion (kWh) Water consump- tion (litre) Approxi- mate pro- gramme duration (minutes) Remain- ing moisture (%) 1) L 71060 SLCS Remain- ing moisture (%) 1) L 71260 SLCS Wool/Hand wash30 °C 2 0.25 55 56 32 30 Standard cotton programmes Standard60 °C cot-ton 6 0.769...

fore you put them in the appliance.Make sure not to put too much laun-dry in the drum. 3. Close the door. Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry. 9.2 Filling the detergent and additives The detergent compartment for the ...

Check the position of the flap 1. Pull out the detergent dispenser un-til it stops. 2. Press the lever down to remove thedispenser. 3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid d...

5. Press button 4 to start the pro- gramme. The indicator of button 4 is on. The drain pump can operate fora short time when the appliancefills water. 9.4 Interrupt a programme 1. Press button 4 . The indicator flashes. 2. Press button 4 again. The washing programme continues. 9.5 Cancel a programme...

When you activate the applianceagain, the display show the endof the last set programme. Turnthe programme knob to set anew cycle. • Remove the laundry from the appli- ance. Make sure that the drum is emp-ty. • Keep the door ajar, to prevent mildew and odours. • Close the water tap. The washing prog...

• If you use liquid detergents, do not set the prewash phase. • If your appliance has not the deter- gent dispenser with the flap device,add the liquid detergents with a dos-ing ball. 10.4 Water hardness If the water hardness in your area is highor moderate, we recommend that youuse a water softener...

11.4 Door seal Regularly examine the seal and removeall objects from the inner part. 11.5 Drum Regularly examine the drum to preventlimescale and rust particles.Only use special products to remove rustparticles from the drum.To do this: • Clean the drum with special product for stainless steel. • St...

11.7 Drain pump Regularly examine the drainpump and make sure that it isclean. Clean the pump if:• The appliance does not drain the wa- ter. • The drum cannot turn.• The appliance makes an unusual noise because of the blockage of the drainpump. • The display shows an alarm code be- cause of the prob...

7. Make sure that the impeller of thepump can turn. If this does not oc-cur, contact the service centre. 2 1 8. Clean the filter under the water tapand put it back in the pump into thespecial guides. 9. Make sure that you tighten correctlythe filter to prevent leakages. 10. Close the drain pump door...

4. Remove the inlet hose behind theappliance. 5. Clean the filter in the valve with astiff brush or a towel. 45° 20° 6. Install again the inlet hose. Makesure that the couplings are tight toprevent leakages. 7. Open the water tap. 11.9 Emergency drain Because of a malfunction, the appliancecannot dr...

• - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on. WARNING! Deactivate the appliance beforeyou do the checks. Problem Possible cause Possible solution The appliancedoes not fill withwater. The water tap is closed. Open...

Problem Possible cause Possible solution The filter of the drainpump is blocked. Clean the filter of the drainpump. Refer to 'Care and clean-ing'. Balance problems withthe laundry load. Adjust manually the items in thetub and start the spin phaseagain. The programmedoes not start. The mains plug is ...

Problem Possible cause Possible solution You did not remove thestubborn stains beforeyou wash the laundry. Use special products to removethe stubborn stains. Incorrect temperaturewas set. Make sure that you set the cor-rect temperature. Too much laundry load. Decrease the laundry load. After the che...

• Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom the couplings. Do not use an extension hose ifthe inlet hose is too short. Con-tact the service centre for the re-placement of the inlet hose. Water-stop device A The inlet hose has a...

• On the edge of a sink.• Make sure that the plastic guide can- not move when the appliance drains.Attach the guide to the water tap orthe wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into adrain pipe at a height of not less than60 cm and not more than 100 cm. Theend o...

14. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle wasteof electrical and electronic appliances. Do not disposeappliances marked with the symbol with the household waste. ...