Page 2 - CUSTOMER CARE AND SERVICE
CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION.............................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. • Old hose sets must not be reus...
Page 5 - INSTALLATION
2.2 Electrical connection • The appliance must be earthed. • Always use a correctly installed shockproof socket. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Do not use multi-plug adapters and extension cables. • Make sur...
Page 6 - Unpacking
3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Use a cutter to cut through external film. 2. Remove the external film. 3. Remove the cardboard top and the polystyrene packaging materials. 4. Open the door and remove ...
Page 9 - Water drainage
20 O 20 O 45 O 45 O Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use ...
Page 10 - PRODUCT DESCRIPTION; Appliance overview
4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5. Without the plastic hose guide: Put the drain hose in the spigot and tighten it with a clip. Refer to the illustration. Make sure that the drain hose makes a loop to prevent particles ...
Page 11 - CONTROL PANEL; Control panel description
1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for levelling the appliance 8 Drain hose 9 Inlet hose connection 10 Mains cable 11 Transit bolts 12 Hose support 5. CONTROL PANEL 5.1 Control panel description 2 3 6 12 11 10 8 1 4 5 7 9 1 Program...
Page 12 - Display
5.2 Display MIX Maximum load indicator. The indicator flashes during the laundry load estimation. Door locked indicator. Delay start indicator. The digital indicator can show:• Programme duration (e. g. ). • Delay time (e. g. or ). • Cycle end ( ).• Warning code ( ). Washing phase indicator. It flas...
Page 13 - DIAL AND BUTTONS; Introduction
Extra silent indicator. Time saving indicator. 6. DIAL AND BUTTONS 6.1 On/Off Pressing this button for a few seconds allows to activate or deactivate the appliance. Two different tunes sound while switching the appliance on or off.As the Stand-by function automatically deactivates the appliance to d...
Page 14 - Rinse; Soft Plus
The appliance empties the water out automatically after 18 hours approximately. 6.5 Stains/Prewash Press this button repeatedly to activate one of the two options.The relevant indicator goes on in the display.• Stains Select this option to add an anti-stain phase to a programme in order to treat hea...
Page 15 - Delay Start; PROGRAMMES; Programme Chart
6.10 Delay Start With this option you can delay the start of a programme in a more convenient time.Touch the button repeatedly to set the required delay. The time increases by steps of 30 minutes up to 90' and from 2 hours up to 20 h.After touching the Start/Pause button,the display shows the indica...
Page 18 - Woolmark Apparel Care -
Programme Cottons Synthetics Delicates Wool/Silk Anti-Allergy 20 min. - 3 kg Outdoor Duvet Easy Iron Drain/Spin ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Stains 1) ■ ■ ■ ■ ■ Prewash ■ ■ ■ ■ ■ Extra rinse ■ ■ ■ ■ ■ ■ Rinse only ■ ■ ■ ■ ■ ■ ■ ■ ■ 2) ■ ■ ■ ■ Time Save 3) ■ ■ ■ ■ Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Soft Plus ■...
Page 19 - SETTINGS; Child Lock; BEFORE FIRST USE; Activating the appliance
8. SETTINGS 8.1 Child Lock With this option you can prevent children from playing with the control panel.• To activate/deactivate this option, touch the Spin and the Stain/Prewash buttons simultaneously until theindicator comes on/goes off on the display. You can activate this option:• After you tou...
Page 21 - Setting a programme; Starting a programme
4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the deter...
Page 24 - HINTS AND TIPS; The laundry load
Press the On/Off button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drai...
Page 25 - CARE AND CLEANING
• Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains, you can use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water h...
Page 29 - TROUBLESHOOTING
45° 20° 12.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump. 12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° ...
Page 30 - Possible failures
WARNING! Deactivate the appliance before carrying out any check. 13.2 Possible failures Problem Possible solution The programme doesnot start. Make sure that the mains plug is connected to the mains sock-et. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in t...
Page 32 - CONSUMPTION VALUES
Problem Possible solution Too much foam in thedrum during the washingcycle. Reduce the quantity of detergent. After the washing cycle,there are some deter-gent residues in the dis-penser drawer. Make sure that the flap is in the correct position (UP for pow-der detergent - DOWN for liquid detergent)...
Page 33 - TECHNICAL DATA
Programmes Load(kg) Energyconsump-tion (kWh) Waterconsump-tion (litre) Approxi-mate pro-grammeduration(minutes) Remain-ing mois-ture (%) 1) Standard 40°C cotton 4,5 0,61 44 205 52 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.30 0.30 The information given in the chart above is complia...
Page 34 - ACCESSORIES; Available in; ENVIRONMENTAL CONCERNS
16. ACCESSORIES 16.1 Available in www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. 16.2 Fixing plate kit If you install the appliance on a plinth, secure...