AEG L 96485 FL- Manuals

• Do not use multiple plugs and extension cables. There is a risk of fire.• Do not replace or change the mains cable. Contact the service centre.• Make sure not to cause damage to the mains plug and cable.• Connect the mains plug to the mains socket only at the end of the installation. Make sure tha...

PRODUCT DESCRIPTION 1 2 3 9 10 6 5 7 8 4 11 12 13 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Internal lamp 6 Rating plate 7 Drain pump 8 Feet for the appliance level 9 Water drain hose 10 Water inlet hose 11 Mains cable 12 Transit bolts 13 Feet for the appliance level Product de...

ACCESSORIES 1 2 3 4 1 Spanner To remove the transit bolts. 2 Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. 3 Anti-flood inlet hose To prevent possible leakage 4 Plastic hose guide To connect the drain hose on the edge of a sink. CONTROL PANEL...

TOUCH SCREEN Do not wear gloves when you touch the buttons. Make sure the touch screen and buttons are always clean and dry. AUTO OFF button 1 Press this button to activate or deactivate the appliance. A tune sounds when the appliance is activated. The AUTO OFF function automatically deactivates the...

You can select: SHORTENED DURATION To wash items with daily soil. EXTRA QUICK To wash quickly items with almost no soil. Some programmes accept only one of these functions. EXTRA SPÜLEN BUTTON 9 Touch button 9 to add rinsing phases to a programme. Use this function for persons allergic to detergents...

• You touch the buttons.• The programme is completed.• The appliance has a malfunction. To deactivate/activate the acoustic signals, touch button 10 and button 9 at the same time for 6 seconds.If you deactivate the acoustic signals, they continue operate only when you touch the but - tons and when a...

Programme Temperature Type of load Weight of load Programme de - scription Functions Pflegeleicht 60° - Cold Rinses Short spin Synthetic or mixed fabric items with normal soil. Maximum load 4 kg Wash Rinses Short spin SPIN REDUCTION SPÜLSTOPPFLECKEN 1) VORWÄSCHE 2) EINWEICHEN EXTRA SPÜLENZEIT SPAREN...

Dampf Auffrischen 2) This cycle removes odour from the laundry. Steam does not remove animal odours. Cotton and synthetic items. Do not set the Steam programme for this type of clothes:• Clothes which is not specified on the care label as being suitable for tumble-drying. • Clothes with inclusion of...

2. Put a small quantity of detergent in the main wash compartment of the detergent dis - penser. Set and start a programme for cotton at the highest temperature without laun - dry. This removes all possible dirt from the drum and the tub. Language setting The first time you activate the appliance, t...

ACTIVATING THE APPLIANCE AND SETTING A PROGRAMME For a correct operation of the weight sensor, activate the appliance and set the programme BEFORE you put the laundry in the drum. 1. Press button 1 to activate the appliance. 2. Turn the programme knob ( 2 ) to the necessary programme or touch one of...

Make sure not to have the laundry out of the drum between the seal and the door. There is the risk of water leakage or damage laundry. USING THE DETERGENT AND ADDITIVES The detergent compartment for the prewash phase and the soak programme. Add the detergent for prewash and soak before the start of ...

Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dis - penser. 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick li...

You cannot set the delay start with the Steam programme. STARTING A PROGRAMME 1. Touch button 6 to start the programme. The indicator of button 6 stops to flash and is on with red colour. If a delayed start is set, the appliance starts the countdown. The appliance adjust automatically the cycle time...

If you deactivate the appliance, it is necessary to set the programme again. AT THE END OF PROGRAMME 1. The appliance stops automatically.2. The acoustic signals operate, if it is active.3. In the display goes on and the message tells you that the programme is completed.4. The indicator of button 6 ...

Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 CARE AND CLEANING WARNING! Disconnect the appliance from the mains supply before you clean it...

Door seal Regularly examine the seal and remove all objects from the inner part. Drum Regularly examine the drum to prevent limescale and rust particles. Only use special products to remove rust particles from the drum. To do this:• Clean the drum with special product for stainless steel.• Start a s...

5. Clean the dispenser recess with a brush.6. Put back the dispenser in the recess. Drain pump Regularly examine the drain pump and make sure that it is clean. Clean the pump if:• The appliance does not drain the water.• The drum cannot turn.• The appliance makes an unusual noise because of the bloc...

1 2 5. When the container is full of water, put the drainage duct back again and emp - ty the container. Do steps 4 and 5 again and again until no more water flows out from the drain pump. 6. Pull back the drainage duct and turn the filter to remove it. 7. Remove fluff and objects from the pump. 8. ...

To clean the water inlet filters: 1. Close the water tap.2. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 4. Remove the inlet hose behind the ap - pliance. 5. Clean the filter in the valve with a stiff brush or a towel. 45° 35° 6. Install a...

WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. TROUBLE SHOOTER AND SERVICE The start of the appliance does not occur or it stops during operation. Try to find a solution to the ...

Problem Possible cause Possible solution You did not remove the stub - born stains before you wash the laundry. Use special products to remove the stubborn stains. You set a not correct tempera - ture. Make sure that you set the correct tem - perature. Too much laundry load. Decrease the laundry loa...

Product number (PNC) .................. Serial number (S.N.) .................. TECHNICAL DATA Dimensions Width / Height / Depth 600 / 850 / 600 mm Total depth 640 mm Electrical connection: Voltage Overall power Fuse Frequency 230 V 2200 W 10 A 50 Hz Water supply pressure Minimum 0,5 bar (0,05 MPa) ...

12. Replace the plastic spacers with the plastic caps. You can find these caps in the user manual bag. WARNING! Remove all the packaging and the transit bolts before you install the appliance. We recommend that you keep the packaging and the transit bolts for when you move the appliance. Positioning...

CAUTION! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. The inlet hose 35 O 35 O 35 O 45 O 45 O 45 O • Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the correct position. • Connect the wate...

Water drainage There are different procedures to connect the drain hose: With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide cannot move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illust...