AEG L 75280 FL- Manuals

5. CONTROL PANEL 1 2 3 4 5 6 7 8 9 10 1 On/Off button ( Marche/Arrêt ) 2 Programme knob 3 Display 4 Start Pause button ( Départ/Pause ) 5 Delay start button ( Départ Différé ) 6 Time saving button ( Gain de Temps ) 7 Extra rinse button ( Rinçage Plus ) 8 Stain button ( Taches ) 9 Spin reduction butt...

C • The display symbols. 2) Symbols Description Washing phase Rinse phases Spin phase Child lock You cannot open the appliance door when the symbol ison.You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: • There is water in the drum.• The 'Rin...

6. PROGRAMMES ProgrammeTemperature Type of loadmax. weight ofload Cycle description Functions Blanc/Couleurs 95° - Cold White and colouredcotton with normalsoil.max. 8 kg WashRinsesLong spin SPIN REDUC-TIONRINSE HOLDSTAIN 1) EXTRA RINSETIME SAVE 2) Blanc/Couleurs+ Prélavage 95° - Cold White and colo...

ProgrammeTemperature Type of loadmax. weight ofload Cycle description Functions Essorage / Vi-dange 4) All fabricsThe maximum loadof the laundry is re-lated to the type oflaundry. Drainage of thewaterSpin phase at themaximum speed. SPIN REDUC-TIONNO SPIN Rinçage Cold Hand washingitems. RinsesLong sp...

The washing temperature of the washing phase may differ from the temperature de- clared for the selected programme. STEAM PROGRAMMES Programme 1) Type of load Max. load Steam Rafraîchir This cycle removes odoursfrom the laundry. Steam does not re-move animal odours. Cotton and synthetic items. up to...

Programmes Load (kg) Energy consump- tion (kWh) Water con- sump- tion (li- tre) Approxi- mate pro- gramme duration (mi- nutes) Remain- ing mois- ture (%) 1) L 75280 FL Remain- ing mois- ture (%) 1) L 75480 FL Standard cotton programmes Standard 60°C cotton 8 1.04 46 208 53 52 Standard 60°C cotton 4 ...

Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry. 8.2 FIlling the detergent and additives The detergent compartment for the prewash phase and thesoak programme.Add the detergent for prewash and soak before the start of theprogramm...

Check the position of the flap 1. Pull out the detergent dispenser un-til it stops. 2. Press the lever down to remove thedispenser. 3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid d...

• The door lock symbol goes off.• Press button 1 to deactivate the ap- pliance. After five minutes from theend of the programme, the energysaving function automatically deacti-vates the appliance. When you activate the applianceagain, the display show the endof the last set programme. Turnthe progra...

• Do not mix different types of deter- gents. • To help the environment, do not use more than the correct quantity of de-tergent. • Obey the instructions that you find on the on packaging of these products. • Use the correct products for the type and colour of the fabric, the pro-gramme temperature ...

• Set the hottest cotton wash pro- gramme • Use a correct quantity of powder de- tergent with biological properties. After each wash, keep the door open fora while to prevent mould and to let un-pleasant smells go out. 10.4 Door seal Regularly examine the seal and removeall objects from the inner pa...

5. Clean the dispenser recess with abrush. 6. Put back the dispenser in the recess. 10.7 Drain pump Regularly examine the drainpump and make sure that it isclean. Clean the pump if:• The appliance does not drain the wa- ter. • The drum cannot turn.• The appliance makes an unusual noise because of th...

1 2 5. When the container is full of water,put the drainage duct back againand empty the container. Do steps 4and 5 again and again until no morewater flows out from the drainpump. 6. Pull back the drainage duct and turnthe filter to remove it. 7. Remove fluff and objects from thepump. 8. Make sure ...

To clean the water inlet filters: 1. Close the water tap. 2. Remove the water inlet hose fromthe water tap. 3. Clean the filter in the inlet hose witha stiff brush. 4. Remove the inlet hose behind theappliance. 5. Clean the filter in the valve with astiff brush or a towel. 45° 20° 6. Install again t...

11. TROUBLESHOOTING The start of the appliance does not oc-cur or it stops during operation.First try to find a solution to the problem(refer to the table). If not, contact theservice centre. With some problems, the acousticsignals operate and the display showsan alarm code: • - The appliance does n...

Problem Possible cause Possible solution The appliance fillswith water anddrain immediately. The end of the drainhose is too low. Make sure that the drain hose isin the correct position. The washing re-sults are not satis-factory. The detergent you usedwas not sufficient or cor-rect. Increase the de...

1 2 7. Remove the polystyrene protectionfrom the bottom. 8. Pull up the appliance in vertical po-sition. 9. Remove the power supply cable andthe drain hose from the hose hold-ers. 10. Remove the three bolts. Use the keysupplied with the appliance. 11. Pull out the plastic spacers. 12. Put the plasti...

• Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom the couplings. Do not use an extension hose ifthe inlet hose is too short. Con-tact the service centre for the re-placement of the inlet hose. Water-stop device A The inlet hose has a...

• On the edge of a sink.• Make sure that the plastic guide can- not move when the appliance drains.Attach the guide to the water tap orthe wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into adrain pipe at a height of not less than60 cm and not more than 100 cm. Theend o...

13. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle wasteof electrical and electronic appliances. Do not disposeappliances marked with the symbol with the household waste. ...