AEG HG654820UM- Manuals

Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,

CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION.............................................

Page 4 - SAFETY INSTRUCTIONS

• CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. • WARNING: Danger of fire: Do not store items on the cooking surfaces. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can...

Page 7 - INSTALLATION

the room where the appliance is installed. • Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present. • This appliance is for cooking purpose...

Page 8 - Gas Connection

However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³.If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements...

Page 9 - Electrical connection; Replacement of the

3.4 Electrical connection • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug (if applicable). • The appliance must not be connected with an extension cable, an adapter or a multiple socket. There is a risk of fire. • Do not let the power cable to heat up to a tempe...

Page 10 - Assembly

To replace the connection cable use only H05SS-F T180 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/ green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A). A B 1. Connect the green an...

Page 11 - Possibilities for insertion

5. 6. B A A) supplied seal B) assembled bracket 7. CAUTION! Install the appliance only on a worktop with flat surface. 3.7 Possibilities for insertion The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. The burner ...

Page 12 - PRODUCT DESCRIPTION; Cooking surface layout; DAILY USE; Burner overview

4. PRODUCT DESCRIPTION 4.1 Cooking surface layout 1 2 3 4 1 Rapid burner 2 Auxiliary burner 3 Semi-rapid burner 4 Control knobs 4.2 Control knob Symbol Description no gas supply / off posi-tion Symbol Description ignition position / maxi-mum gas supply minimum gas supply 5. DAILY USE WARNING! Refer ...

Page 13 - Turning the burner off; HINTS AND TIPS; Cookware

2. Keep the control knob pushed for equal or less than 10 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the flame spreader is in correct position. WARNING! Do not ke...

Page 14 - Diameters of cookware; CARE AND CLEANING; General information; Pan supports

CAUTION! Make sure that pot handles are not above the front edge of the cooktop. CAUTION! Make sure that the pots are placed centrally on the burner in order to get maximum stability and to get lower gas consumption. 6.2 Diameters of cookware Use cookware with diameters applicable to the size of bur...

Page 15 - Cleaning the hob; Cleaning the flame; TROUBLESHOOTING

correspondence with the grips placed at the base of the burner as shown in the picture. This way, the pan support will be stable and fixed. 7.4 Cleaning the hob • Remove immediately: melted plastic, plastic foil, sugar and food with sugar. If not, the dirt can cause damage to the hob. Take care to a...

Page 16 - If you cannot find a

8.1 What to do if... Problem Possible cause Remedy There is no spark when youtry to activate the spark gen-erator. The hob is not connected toan electrical supply or it isconnected incorrectly. Check if the hob is correctlyconnected to the electricalsupply. The fuse is blown. Make sure that the fuse...

Page 17 - TECHNICAL DATA; Hob dimensions; Bypass diameters; Other technical data

8.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO. 03 IT MADE IN ITALY TYPE IP20 0049 A B C A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Car...

Page 18 - Gas burners for NATURAL GAS G20 20 mbar; ENERGY EFFICIENCY; Product information according to EU 66/2014

Electric supply: 220-240 V ~ 50-60 Hz 3 core flexible cable with non rewireable plugfitted with a 3 amp cartridge fuse Appliance cate-gory: I2H Gas connec-tion: R 1/2" Applianceclass: 3 9.4 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK Rapid 2,9 1,...

Page 19 - ENVIRONMENTAL CONCERNS

• If it is possible, use a pressure cooker. Refer to its user manual. 11. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do no...