AEG HG654320- Manuals

• Before installation, make sure that the local supply conditions (gas type and pressure) agree with the adjustment of appliance. The adjustment conditions for the appliance are on the rating plate, which you can find near the gas supply pipe. • This appliance is not connected to a combustion produc...

INSTALLATION WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Important safety requirements This hob must be installed in accordance with the Gas Safety (Installa...

1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the knob. 4. With a thin screwdriver, adjust the by - pass screw position. 1 1 The by - pass screw – If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment screw in. – If you change from liquid gas t...

Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit. 5...

OPERATION Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner:1. Turn the control knob counterclockwise to the maximum p...

If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installa- tion or a power cut. It is normal. Turning the burner off To put the flam...

WARNING! Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to achieve maximum stability and to obtain lower gas consumption. Do not place unstable or deformed pots on the rings to prevent from spill and injury. WARNI...

• Be very careful when you replace the pan supports to prevent the hob top from damage. After cleaning, dry the appliance with a soft cloth. Removing the dirt: 1. – Remove immediately: melting plastic, plastic foil, and food containing sugar. – Stop the appliance and let it cool down before you clea...

Problem Possible cause Remedy The flame is blow out immedi- ately after ignition • Thermocouple is not heated sufficient • After lightning the flame, keep the knob pushed for approximately 5 seconds. The gas ring burns unevenly • Burner crown is blocked with food residues • Make sure that the inject...

TECHNICAL DATA Hob dimensions Width: 595 mm Length: 525 mm Hob recess dimensions Width: 560 mm Length: 480 mm Heat input Rapid burner: 2.9 kW Semi - rapid burner: 1.9 kW Auxiliary burner: 1.0 kW TOTAL POWER: G20 (2H) 20 mbar = 7.7 kW G30 (3+) 28 - 30 mbar = 545 g/h G31 (3+) 37 mbar = 536 g/h Electri...

BURNER NORMAL POWER REDUCED POWER NORMAL POWER NATURAL GAS G20 (2H) 20 mbar LPG (Butane/Propane) G30/G31 (3+) 28 - 30/37 mbar kW kW inj. 1/100 mm m³/h inj. 1/100 mm G30 28 - 30 mbar G31 37 mbar g/h g/h Semi - rap- id 1.9 0.45 96 0.181 71 138 136 Rapid 2.9 (natu- ral gas) 2.7 (LPG) 0.75 119 0.276 86 ...