AEG FSK73400P- Manuals

3 Filters 4 Rating plate 5 Salt container 6 Air vent 7 Rinse aid dispenser 8 Detergent dispenser 9 Cutlery basket 10 Lower basket 11 Upper basket 3.1 TimeBeam The TimeBeam is a display that is shown on the floor below the appliance door. • When the programme starts, the programme duration comes on. ...

4.1 Indicators Indicator Description End indicator. Rinse aid indicator. It is always off while the programme operates. Salt indicator. It is always off while the programme operates. 5. PROGRAMMES Programme Degree of soilType of load Programme phases Options P1 1) • Normal soil• Crockery and cutlery...

Programme Degree of soilType of load Programme phases Options P5 • Normal or light soil • Delicate crock- ery and glass-ware • Wash 45 °C• Rinses• Dry • XtraDry 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is ...

5.2 Information for test institutes For all the necessary information for test performance, send an email to: [email protected] Write down the product number (PNC) that is on the rating plate. 6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme...

1. To enter the user mode, press andhold simultaneously and until the indicators , , , and start flashing and the display is blank. 2. Press . • The indicators , , and are off. • The indicator still flashes. • The display shows the current setting: = AirDry activated. 3. Press to change the setting:...

not come on or it flashes quickly for a few seconds and then goes off. The display shows the updated programme duration. 8. BEFORE FIRST USE 1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 2. Fill...

M A X 1 2 3 4 + - A B D C CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Press the release button ( D ) to open the lid ( C ). 2. Pour the rinse aid in the dispenser ( A ) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to...

10. HINTS AND TIPS 10.1 General The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment.• Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if...

• Make sure that the spray arm can move freely before you start a programme. 10.5 Before starting a programme Make sure that:• The filters are clean and correctly installed. • The cap of the salt container is tight. • The spray arms are not clogged. • There is dishwasher salt and rinse aid (unless y...

5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter ( A ). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters ( B ) and ( C ). 8. Put back the filter ( B ) in the flat filter ( A ). Turn ...

Problem and alarm code Possible cause and solution The program lasts too long. • Select the TimeSaver option to shorten the program time. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. The remaining time in thedisplay increases and skipsnearly to...

Problem Possible cause and solution Limescale deposits on the ta-bleware, on the tub and onthe inside of the door. • The level of salt is low, check the refill indicator.• The cap of the salt container is loose.• Your tap water is hard. Refer to "The water softener" . • Even using multi-func...