AEG F78601VI1P- Manuals

Programme Degree of soilType of load Programme phases Options P6 5) • Normal soil• Crockery and cutlery • Prewash• Wash 50 °C• Rinses• Dry • XtraDry 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard...

6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. In user mode, the following settings can be changed: • The activation or the deactivation of the acoustic signal for end of programme...

• The display shows the current setting: = the rinse aid dispenser is activated (factory setting). 3. Press to change the setting. = the rinse aid dispenser is deactivated. 4. Press the on/off button to confirm the setting. 6.4 Acoustic signals Acoustic signals sound when a malfunction of the applia...

washing and the drying phases are shorter.The total programme duration decreases by approximately 50%.The washing results are the same as with the normal programme duration. The drying results can decrease. How to activate TimeSaver Press , the related indicator comes on. If the option is not applic...

9. DAILY USE 1. Open the water tap. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the rinse aid indicator is on, fill the rinse aid dispenser. 3. Load the baskets. 4. Add the detergent. 5. Set and start the correct programme f...

If the door is opened for more than 30 seconds during the drying phase, the running programme will end. Cancelling the delay start while the countdown operates When you cancel the delay start you have to set the programme and options again.Press and hold RESET until the appliance is in programme sel...

• Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses. • Put small items in the cutlery basket. • Put light items in the upper basket. Make sure that the items do not move. • Make sure that the spray arm can move ...

4. To engage again the spray arm to the basket, press the spray arm upwards in the direction indicated by the lower arrow and simultaneously turn it counterclockwise until it locks into place. 11.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do n...

Refer to "Before first use" , "Daily use" , or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. If the problem occurs again, contact an Authorised Service Centre.For alarm codes not described in the table,...

Problem Possible cause and solution Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener" . • Silver and stainless steel cutlery were placed together. Avoid to put silver and stainless steel items close to-gether. There are residues ...

Power consumption Off-mode (W) 0.10 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. 14. INSTALLATION If floor is not level, adjustlevelling legs t...

• If water pressure is in excess of 800 kPa, a pressure reducing valve should be used. Check for leaks. • If water temperature is in excess of 60° C, a tempering valve should be used. Check for leaks. CAUTION! Always use new hoses when you connect the appliance to the water mains. Old hoses must not...

FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664OR EMAIL [email protected] For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest state spare parts centre in Australia PLEASE CAL...