AEG CHDL4150ML/GB- Manuals

Page 3 - Contents

3 Contents Safety warnings 4 For the User 4 For the Installer 4 Description of the Appliance 6 Extractor version 6 Filter Version 7 Control Panel 8 Maintenance and care 9 Cleaning the hood 9 Metal grease filter 9 Removing the metal grease filter 9 Charcoal filter 10 Changing the light bulb 11 What t...

Page 4 - Safety warnings; For the User

4 Safety warnings For the User • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal firedcookers it is essential to avoid open flam...

Page 6 - Description of the Appliance; Extractor version

6 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version • In thi...

Page 7 - Control Panel

7 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated.Turn the hood on a few minutes before you start cooking, you willthen get an under pressure in the kitchen. The hood should be lefton after cooking for about 15 m...

Page 8 - Maintenance and care; Cleaning the hood; Metal grease filter

8 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products.• Never insert ...

Page 10 - Charcoal filter

10 Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG charcoal filter (see special accessories). • Replacing the charcoal filter The charcoal filters cannot be cleaned, we recommend that theyshou...

Page 11 - Warning; Changing the light bulb

11 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are thereforestrongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappro...

Page 12 - What to do if

12 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that:The hood is connected to theelectricity supply.Check that the fan speed control isset to 1, 2 or 3. The cooker hood is not working Chec k tha...

Page 14 - Guarantee conditions

14 Guarantee conditions Guarantee ConditionsAEG offer the following guarantee to the first purchaser of this appliance.1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified bypurchase invoice or similar documentatio...

Page 16 - Technical Specifications; Mounting accessories included; Electrical connection; Safety warnings for the electrician

16 Technical Specifications Dimensions (in cm): Height 137 Width 510 Depth 285 Maximum absorbed power: 220 W Motor absorption: 140 W Lighting: 2 x 40 W (E14) Length of the cable: 150 cm Mounting accessories included 1 Flange Ø 120 mm1 Adapter Ø 120/100 mm4 wood-screws 2,9 x 16 Electrical connection ...

Page 19 - Removing the hood from cabinet

19 Removing the hood from cabinet Follow these steps: • Remove the grease filter.• Remove the 4 additional screws from the frame.• Loosen the screws on the two fixing springs. Fig. 8. • Push a flat screwdriver into the hole for the fixing springs (right and left) and push each of the fixing springs ...