Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. OPERATION................................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. • Do not store explosive substances such as aerosol cans with a flammable propellant...
Page 6 - OPERATION; Control Panel
3. OPERATION 3.1 Control Panel 5 6 4 3 2 1 1 Display 2 Temperature warmer button 3 Temperature colder button 4 OK 5 Mode 6 ON/OFF It is possible to change predefined sound of buttons by pressing together Mode and temperature colder button for a few seconds. Change is reversible. 3.2 Display A C B D ...
Page 8 - DAILY USE; Cleaning the interior; Storage of frozen food
4. DAILY USE WARNING! Refer to Safety chapters. 4.1 Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand- new product, then dried thoroughly. CA...
Page 10 - TROUBLESHOOTING
This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. The accessories and parts of the appliance are not suitable for washing in a dishwasher. 6.2 Periodic cleaning CAUTION! Do not pull, move or damage any p...
Page 12 - Closing the door
Problem Possible cause Solution The compressor does notstart immediately afterpressing the "FROSTMAT-IC", or after changing thetemperature. This is normal, no error hasoccurred. The compressor starts after aperiod of time. Water flows on the floor. The melting water outlet isnot connected to...
Page 13 - INSTALLATION; Location; Electrical Connection
8. INSTALLATION 8.1 Location Refer to the assembly instructions for the installation. To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlight etc. Make sure that air can circulate freely around the back of the cabinet. 8.2 Position...
Page 14 - Ventilation requirements; NOISES; BRRR; OK
3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp ( E ) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance r...