AEG A72710GNW0- Manuals

3. CONTROL PANEL 5 6 4 3 2 1 1 Display 2 Temperature warmer button 3 Temperature colder button 4 OK button 5 Mode button 6 ON/OFF button It is possible to change predefinedsound of buttons to a loudly one bypressing together Mode button andTemperature colder button for someseconds. Change is reversi...

4. DAILY USE 4.1 Freezing fresh food The freezer compartment is suitable forfreezing fresh food and storing frozenand deep-frozen food for a long time.To freeze fresh food activate the FROST-MATIC function at least 24 hours beforeplacing the food to be frozen in thefreezer compartment.Place the fres...

4.4 Removal of freezing baskets and glass shelves from the freezer 2 1 Some of the freezing baskets have a limitstop to prevent their accidental removalor falling out. At the time of its removalfrom the freezer, pull the basket towardsyourself and, upon reaching the endpoint, remove the basket by ti...

• The thermic dilatation might cause a sudden cracking noise. It is natural,not dangerous physical phenomenon.This is correct. • When the compressor switches on or switches off, you will hear a faint"click" of the temperature regulator.This is correct. 5.2 Hints for energy saving • Do not op...

CAUTION! Unplug the appliance before car-rying out any maintenance oper-ation. This appliance contains hydrocar-bons in its cooling unit; mainte-nance and recharging musttherefore only be carried out byauthorized technicians. 6.2 Periodic cleaning The equipment has to be cleaned regu-larly:• clean t...

Problem Possible cause Solution The temperature inthe freezer is toowarm. Food is too near to eachother. Store food so that there iscold air circulation. Large quantities of foodto be frozen were put inat the same time. Insert smaller quantities offood to be frozen at thesame time. The appliance doe...

8.2 Location A B 100 mm min 20 mm The appliance should be installed wellaway from sources of heat such as radia-tors, boilers, direct sunlight etc. Ensurethat air can circulate freely around theback of the cabinet. To ensure best per-formance, if the appliance is positionedbelow an overhanging wall ...

8.3 Electrical Connection A B C D E CAUTION! Any electrical work required toinstall this appliance should becarried out by a qualified electri-cian or competent person. WARNING! This appliance must be earthed.The manufacturer declines any li-ability should these safety meas-ures not be observed. The...

8.4 Rear spacers 2 4 3 1 You can find the two spacers in the bagwith documentation.Do these steps to install the spacers: 1. Release the screw. 2. Engage the spacer below the screw. 3. Turn the spacer to the right position. 4. Tighten again the screws. 8.5 Levelling Accurate levelling prevents the v...

8.6 Door reversibility 1 2 3 8 6 7 To carry out the following opera-tions, we suggest that this bemade with another person thatwill keep a firm hold on the doorsof the appliance during the oper-ations. To change the opening direction of thedoor, do these steps:• Remove the plug from the power socket...

1 2 3 6 5 4 • Remove the handle. Unscrew the top handle bracket from the handle rod(1). Unscrew the bottom handle brack-et from the door (2) • Unscrew the top handle bracket from the door (3). • Re-screw the handle bracket on the door (4). Turn the handle bracket withthe handle and screw them to the...

SSSRRR! SSSRRR! CRACK! CRACK! 10. TECHNICAL DATA Dimension Height 1850 mm Width 600 mm Depth 660 mm Rising Time 20 h Voltage 230-240 V Frequency 50 Hz The technical information are situated inthe rating plate on the internal left sideof the appliance and in the energy label. 11. ENVIRONMENT CONCERNS...