Page 2 - Contents
2 Printed on recycled paper.AEG – putting words into action. Contents Introduction 3 Extraction mode 3 Recirculation mode 4 Electrical connection for the UK 5 Technical Details 6 Installation 7 Safety warnings 7 Installation 8 Hood Operation 11 Safety warnings for user 12 Maintenance and care 13 Met...
Page 3 - Introduction; Extraction mode
3 Introduction Extraction mode ● The hood is supplied as an extractor unit and can also be used as afiltered function by fitting activated carbon filters (available as anaccessory). ● You will need original AEG activated carbon filters for the filteredfunction (see Accessories). ● The air is forced ...
Page 4 - Recirculation mode
4 Recirculation mode ● The air is filtered through an activated carbon filter and passedback into the kitchen through the top outlet duct grids. ● You will need an original AEG KF 825 activated carbon filter for thefiltering function. (See Accessories). ● Fix the deflector with two screws Ø3,5x6,5. ...
Page 5 - Electrical connection for the UK; Appliances with 2 wires; coloured in accordance with the following code:
5 Electrical connection for the UK Appliances with 2 wires WARNING: DOUBLE INSULATED - DO NOT EARTHThe appliance must be connected to fixed wiring with a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance to be connected only by a qualified electri...
Page 6 - Technical Details
6 Technical Details Dimensions (825 D):Height x Width x Depht (in cm) 84-117 x 59,9 x 51.5 Dimensions (8259 D):Height x Width x Depht (in cm) 84-117 x 89,9 x 51.5 Weight (825 D):Net: 10,7 kg Gross: 16,2 kg Weight (8259 D):Net: 13,1 kg Gross: 19,6 kg Maximum absorbed power: 250W Motor absorption: 1 x...
Page 7 - Installation; Safety warnings for kitchen unit installer; Electric hob
7 Installation Safety warnings for kitchen unit installer ● When used as an extractor unit, the hood must be fitted with a120mm diameter hose. ● If the fumes must be forced out through the wall, you must obtaina MKZ sizable wall exhaust pipe (with external exhaust and airintake), E-Nr.- 610 899 004 ...
Page 11 - Hood Operation; the light switch switches the hood lamp on and off
11 O I O 1 2 3 i Hood Operation ● The hood is fitted with a variable speed motor. The most effectiveuse of the hood is obtained by switching it on a few minutes beforeyou start cooking and leaving it on for approximately 15 minutesafter you have finished, thus ensuring all cooking odours areeliminat...
Page 12 - Safety warnings for user; Never carry out any flambé cooking under the hood.
12 Safety warnings for user ● Never leave a cooking hob or ring on without a pot or panon top of it, to avoid the possibility of excess heat damagingthe unit. Gas, oil or coal cooker flames in particular shouldnever be left uncovered. ● Special care should be taken when using deep fat fryers sinceth...
Page 13 - Maintenance and care; Metal grease filter; Hand washing
13 Maintenance and care ● The hood must always be disconnected from the mainspower supply before beginning any maintenance work. Metal grease filter ● The purpose of the grease filters is to aspirate grease particleswhich form during cooking and it must always be used, either inextraction or recircu...
Page 14 - Carbon filter; To remove proceed in reverse order.
14 Carbon filter ● The activated carbon filter should only be used if you want to usethe hood in the recirculation. ● To do this you will need an original AEG activated carbon filter (seespecial accessories). ● This filter cannot be cleaned or reused. ● As a general rule, the activated carbon filter...
Page 17 - Something not working; Sympton
17 Something not working If your cooker hood fails to work properly please carry out the following checks. Sympton Solution The cooker hood will not start... The hood is connected to the electricity supply.Check that the fan speed control isset to 1, 2 or 3. The cooker hood is not working The fan sp...
Page 18 - Service & Spare Parts
18 Service & Spare Parts If you require a service engineer or wish to purchase spare parts,contact your local AEG Service Centre, by telephoning: 0990 929929 Help us to help youPlease determine your type of enquiry before telephoning. When youcontact us we need to know.1. Your name, address and ...