AEG 72850 - Manuals

Detergent dispenser drawer Compartment for detergent used for prewash . The prewash detergent is added at the beginning of the wash programme. Compartment for powder or liquid detergent used for main wash . Compartment for liquid additives (fabric softener, starch). Compartment for stain remover use...

3 SPIN REDUCTION button ( RPM ) 4 OPTION button ( OPCIONES ) 5 OK button ( OK ) 6 TIME SAVING button ( TIEMPO ) 7 START/PAUSE button ( START/PAUSA ) 8 DELAY START button ( INICIO DIFERIDO ) 9 Display Symbols on the control panel = Handwash = Child Lock Display 9.1 9.2 9.4 9.5 9.6 9.7 9.8 9.3 9.9 9.1...

– After selecting a programme, the duration is displayed in hours and minutes (for ex- ample . The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. – After the programme has started, the time remaining is updated every minute. • Delay start –...

Child safety lock This device permits you to leave the appliance unattended and not to worry that children might be injured by or cause damage to the appliance. This function remains able also when the washing machine is not working. To enable (or disable) this option press simultaneously for about ...

2. If required, pour fabric softener into the compartment marked (the amount used must not exceed the MAX mark in the drawer). Close the drawer gently. Turn the programme dial (1) to set the required programme You can choose the right programme for any type of laundry following the descriptions on t...

Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3) When the required programme has been selected, your appliance automatically proposes the maximum spin speed provided for that programme. Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a ...

This option is recommended for heavily soiled laundry. STAIN option Select this option to treat heavily soiled or stained laundry with stain remover (extended main wash with time optimized stain action phase). The relevant symbol will appear on the display. This option is not available with a temper...

Select the DELAY START (button 8) Before you start the programme , if you wish to delay the start, press the button repeated- ly, to select the desired delay. The corresponding symbol will appear on the display. The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 h...

Opening the door after the programme has started When the machine is working and throughout the delay time the door is locked. If, for any reason, you wish to open the door, set firstly the machine to pause by pressing the button 7 . • If the DOOR symbol disappears, the door can be opened;• If the D...

WASHING PROGRAMMES Programme - Maximum and Minimum Tempera - ture - Cycle Description - Maximum Fabrics Load - Type of Laundry Options Detergent Com - partment ALGODÓN 95° - Cold Main wash - Rinses - Long spin at the maximum spin speedMax. load 7 kg - Reduced load 3.5 kg 1) White and coloured cotton...

Programme - Maximum and Minimum Tempera - ture - Cycle Description - Maximum Fabrics Load - Type of Laundry Options Detergent Com - partment ALGODÓN ECO 60° Main wash - Rinses - Long spin at the maximum spin speed Max. load 7 kg STANDARD PROGRAMME for the Energy Label consumption values. White and f...

Rub particularly soiled areas with a special detergent or detergent paste. Treat curtains with special care. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the washing programme charts. General rules:• Cotton, linen: drum full but not too tightly packed...

Ink: depending on the type of ink, moisten the fabric first with acetone 1) , then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with deter- gent paste. Detergents...

11. Replace the filter into the pump by in- serting it correctly into the special guides. Screw the pump cover firmly by turning it clockwise. 12. Refit the flap and close the pump door. WARNING! When the appliance is in use and depending on the programme selected there can be hot water in the pump....

WHAT TO DO IF… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the yellow pilot light ...

Problem Possible cause/Solution The machine fills then empties immediately: The end of the drain hose is too low.• Refer to relevant paragraph in «Water drain- age» section. The machine does not empty and/or does not spin: The drain hose is squashed or kinked. • Check the drain hose connection.The d...

they are the most efficient programmes in terms of combined energy and water consump- tion for washing that type of cotton laundry. They agree with EN60456.The actual water temperature may differ from the declared cycle temperature. INSTALLATION Unpacking All transit bolts and packing must be remove...

6. Fill the smaller upper hole and the two large ones with the corresponding plas- tic plug caps supplied in the bag con- taining the instruction booklet. 7. Connect the water inlet hose as descri- bed under the paragraph «Water inlet». Positioning and levelling Install the machine on a flat hard fl...

Water-stop device The inlet hose is provided with a water stop de- vice, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window «A» . Should this oc- cur, turn the water tap off and refe...

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. ELECTRICAL CONNECTION Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domest...

Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collec- tion containers. Ecological hints To save water, energy and to he...