AEG 600M-ALC- Manuals

Programme Degree of soilType of load Programme phases Options P3 • Heavy soil• Crockery, cut- lery, pots andpans • Prewash• Wash 70 °C• Rinse• Dry • ExtraHygiene• XtraDry• TimeSaver P6 • Normal or light soil • Delicate crock- ery and glass-ware • Wash 45 °C• Rinse• Dry • XtraDry P4 4) • Fresh soil• ...

Programme 1) Water (l) Energy (kWh) Duration (min) P5 14 - 16 1.2 - 1.5 160 - 180 P3 12.5 - 14.5 1.4 - 1.7 170 - 190 P6 12 - 14 0.7 - 0.9 82 - 92 P4 10.5 0.7 38 P8 4 0.01 14 P7 9.0 - 10.0 1.1 - 1.3 230 - 250 1) The pressure and the temperature of the water, the variations of the mains supply, the op...

How to set the MyFavourite programme Press . • The MyFavourite indicator is on. • The display shows the number and the duration of the programme. • If options are saved together with the programme, the indicators related to the options are on. 7. OPTIONS Desired options must be activated every time ...

not come on or it flashes quickly for a few seconds and then goes out. The display shows the updated programme duration. 8. BEFORE FIRST USE 1. Fill the rinse aid dispenser. 2. Open the water tap. 3. Start a program to remove any processing residuals that can still be inside the appliance. Do not us...

Starting a programme 1. Keep the appliance door ajar. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. 3. Press repeatedly until the display shows the number of the programme you want to start. The display will show the programme numb...

11. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. 11.1 Cleaning the filters The filter system is made...

• To maintain the performance of your appliance at its best, we recommend using a specific cleaning product for dishwashers (at least once a month). Follow carefully the instructions on the packaging of the product. 12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Be...

Problem and alarm code Possible solution The program lasts too long. • Select the TimeSaver option to shorten the program time (if applicable). • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. The remaining time in thedisplay increases and skipsnea...

Problem Possible cause and solution Limescale deposits on the tuband on the inside of the door. • Clean the appliance with appliance cleaners which are particularly suitable for this purpose. • Try different detergent.• Contact the detergent manufacturer. Dull, discoloured or chippedtableware. • Mak...

14. INSTALLATION If floor is not level, adjustlevelling legs to suit The hose should not beextended by more than2 metres or water pump-out problems ma y occur Remove entire plasticmembrane from sink trapspigot & fit drain hose to spigotwith clamp There should be a minimum2mm gap between the top ...

Once the installation is completed, make sure that the bottom of the adjustable plinth is aligned with the floor. 14.3 Water inlet hose Connect the inlet hose to a water tap with an external BSP thread spout of 3/4''.For best washing performance it is recommended to connect the appliance to a cold w...

Remove entire internal membrane 15. WARRANTY FOR SALES IN AUSTRALIA AND NEW ZEALANDALL AEG BRANDED APPLIANCES This document sets out the terms and conditions of the product warranties for AEG Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe plac...

Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aegaustralia.com.au FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustrali...