AEG 2807 - Manuals - manualsarea.com

Page 2 - Please read these user instructions carefully.

2 Dear customer! Please read these user instructions carefully. Above all please observe the safety instructions on the first few pagesof these user instructions! Please keep these user instructions for laterreference. Pass them on to any subsequent owner of the appliance. The warning triangle and/o...

Page 3 - Contents; Safety instructions; Disposing of the packaging; Description of the appliance

3 Contents Safety instructions 4 Disposing of packaging and old machine 6 Disposing of the packaging 6 Disposing of your old machine 6 Economical and ecological dishwashing 7 Description of the appliance 8 The inside of the appliance 8 Control panel 9 Before using your dishwasher for the first time ...

Page 4 - Using your dishwasher for its intended purpose

4 Safety instructions The safety of AEG electrical appliances conforms to accepted rules oftechnology and the Appliance Safety Act. We as manufacturers, however, seeourselves as being obliged to familiarise you with the following safetyinstructions. Using your dishwasher for its intended purpose ● O...

Page 5 - Do not rest or sit on the open door or the machine could tilt.

5 ● The water in your dishwasher should not be used for drinking. Detergent residues may still be present in your machine. Make sure you do not splash these caustic residues onto your skin or suffocate yourself! Keep children well away from your dishwasher when its door is open. Your dishwasher in d...

Page 6 - Disposing of packaging and old machine; The plastics are marked as follows:; Disposing of your old machine

Marking of plastic parts for graded recycling: all plastic parts in yourmachine are marked with internationally standardised abbreviations (e.g.<PS> for polystyrene). When your machine is disposed of, this enables plasticwaste to be sorted into individual types for environmentally consciousrec...

Page 7 - Economical and ecological dishwashing; Ensure that the water softener is correctly adjusted.

7 Economical and ecological dishwashing ● Only connect the dishwasher to the hot water supply if your hot water is not electrically heated. ● Ensure that the water softener is correctly adjusted. ● Do not pre-rinse under running water. ● Select the wash programme to suit the nature and degree of the...

Page 8 - The inside of the appliance

8 Description of the appliance 1 2 3 4 5 6 7 8 9 10 11 12 13 14 IN68 The inside of the appliance 1. Water hardness adjustment 2. Levelling spacers 3. Upper basket stop 4. Salt container 5. Large filter 6. Detergent dispenser 7. Control panel 8. Rating plate 9. Rinse aid dispenser 10. Central filter ...

Page 10 - Before using your dishwasher for the first time; Remove all packaging from inside the appliance.; Setting the water hardness range; The higher the content of these salts, the harder your water is.

10 Before using your dishwasher for the first time 1. Ensure that the electrical and water connections comply with the installation instructions. 2. Remove all packaging from inside the appliance. 3. Set the water softener. 4. Pour 1 litre of water inside the salt container and then fill with salt. ...

Page 11 - Filling with special salt; The packaging of dishwasher salt and detergents are often very

11 With a screwdriver turn the selector on theupper front corner of the machine untilthe level required corresponds with themarker. 2 AA05 1 3 5 4 2 If your water is level 0 it is already soft and therefore there is noneed to use salt. In this case adjust the water softener on level 1without using s...

Page 12 - Pour 1 litre of water inside; Screw on the cap tightly.; Salt refill indicator

12 To fill: 1. To fill with salt, unscrew the cap of the salt container. 2. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). 3. Using the funnel provided, pour in the salt until the container is full.Do not worry if water overflows from...

Page 13 - Filling up the rinse-aid

13 The rinse-aid The rinse-aid ensures brilliant crockery and also helps it to dry. It isautomatically dosed in during the hot rinsing cycle. The storagecompartment built in to the in side of the door can hold about 110 ml ofrinse-aid, which will be sufficient for between 16 and 40 dishwashingprogra...

Page 14 - Adjusting the dose; Start from position 3.

14 Adjusting the dose The correct dosage of the rinse-aidshould be regulated on the basis ofthe shine and drying results. For this purpose, set the quantity ofliquid by means of the six-positionselector (C) located on the inside ofthe filler opening (minimum quantityis position 1, maximum quantity i...

Page 15 - Loading cutlery and dishes; Open the door and slide out the baskets.; Do not load very small items which can fall through the baskets.

15 Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. For washing in the dishwasher the following cutlery/dishes are not suitable: ● Cutlery with wooden, horn, china or mother of pearl handles. ● Plastic items that are not h...

Page 16 - The lower basket; - Slightly pull them upward and let

16 The lower basket The lower basket is designed to take saucepans, lids, plates, salad bowls,cutlery etc. Serving dishes and large lids should be arranged around the edge of thebasket, ensuring that the upper spray arm can turn freely. UI19 UI49 The two rear rows of prongs on the lower basket can b...

Page 17 - Cutlery basket

17 Cutlery should be placed in the removable cutlery basket with the handlesfacing downwards. If the handles protrude from the bottom of the basket,obstructing the lower spray arm, load the cutlery with the handles facingdownwards. Mix spoons with other cutlery to prevent the from sticking together....

Page 18 - The upper basket

18 The upper basket The upper basket is designed for plates(dessert plates, saucers, dinner plates up to24 cm in diameter), salad bowls, cups andglasses; these should be arranged as shownin the pictures. Glasses with long stems can be placedupside-down in the raised cup-racks Arrange items on and un...

Page 19 - Adjusting the height of the upper basket; To move to the higher position proceed as follows:

19 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) youcan load them in the lower basket after moving the upper basket to thehigher position. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upp...

Page 20 - Use of detergent; Always close the lid.

20 Use of detergent Attention!Only use detergents specifically designed for use in dishwashers. If using powder detergents proceedas follows: 1. Open the dispenser lid by pulling the catch (D). 2. Add the detergent. As all detergents are not the same, please pay attention to the dosage instructions ...

Page 21 - Compact detergents with enzymes

21 Remember that insufficient quantities of detergent will producepoor washing results whereas an excessive amount of detergentdoes not improve washing results and is also wasteful. Compact detergents with enzymes In these compact powders the environmentally unfriendly components havebeen replaced b...

Page 22 - Washing programmes

22 Washing programmes Programmes Normal 65° with prewash Bio 50° with prewash Normal 65° no prewash Half Load Normal no prewash Half Load Quick Bio 50° no prewash * Quick 65° * Quick 50° Intensive 70° Rinse and Hold Type of soilType of load Normal soil.Crockery and cutlery Normal soil.Crockery and c...

Page 24 - Operating instructions; Check the filters; Close the detergent dispenser lid.

24 Operating instructions 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it...

Page 25 - Start the programme; Turn the water tap on.; At the end of the washing programme

25 7. Start the programme Turn the water tap on. Depress the On/Off push button. The On/Off indicator light will come on and the machine will start. 8. At the end of the washing programme At the end of the washing programme the machine stops automatically. The On/Off indicator light remains on until...

Page 26 - Maintenance and cleaning; Internal and external cleaning; The spray arms do not need cleaning.; Cleaning the central filter; To remove the drain filter

26 Maintenance and cleaning Internal and external cleaning Do not under any circumstances use furniture care products oraggressive cleaners. If necessary, clean the controls only with a soft cloth and pure warm water. The spray arms do not need cleaning. Occasionally check the internal containers, d...

Page 27 - Cleaning the large filter; To remove the large filter

27 Cleaning the large filter (every month) If necessary clean the large filter (B) on both sides under running water,using a brush. To remove the large filter 1. Remove the spray arm by pulling it upwards on one side. 2. Turn the column (C) anticlockwise by 90° and then slide out the filter. 3. Once...

Page 30 - Customer service; To keep these numbers handy, we recommend you enter them here.

30 Customer service In the section "What to do, when...", we have listed the most important faultswhich you can rectify yourself. Should you still wish to call our ServiceCentre for any of the specified faults or because the appliance is beingwrongly operated, the service engineer's visit ca...

Page 31 - Technical data; Technical specifications

31 Technical data This appliance complies with the following E.E.C. Directives:- 73/23/CEE of 19/02/73 (Low Voltage Directive) and subsequentmodifications;- 89/336/CEE of 03/05/89 (Electromagnetic CompatibilityDirective) and subsequent modifications. Technical specifications Dimensions Electrical co...

Page 32 - Hints for test centres; Arrangement upper basket

32 Hints for test centres Before starting any test it is necessary to fill completely with salt the saltcontainer and with rinse aid the rinse aid dispenser. Test standard Load Rinse aid selector Detergent dosage Reference programme EN 50242 position 5 - 25 g in the dispenser- 5 g on the dispenser l...

Page 33 - - Remove the machine’s worktop by; Levelling; Installation

33 Adjusting the worktop You can move the worktop forward orbackward by 25 mm in order to align themachine with other kitchen units.Simply unscrew the two rear retainingscrews, move the top to the requiredposition and then retighten the screws. Fitting under a counter (kitchen worktop or sink) By re...

Page 34 - Connection instructions; Remove all packaging before positioning the machine.; Water supply connections; Nevertheless we advise a cold water supply.

34 Connection instructions Any electrical work required to install this appliance should be carriedout by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carriedout by a qualified plumber or competent person. Remove all packaging before pos...

Page 35 - Water outlet connection; The end of the drain hose can be connected as follows:

35 Water outlet connection The end of the drain hose can be connected as follows: 1. To the sink outlet siphon, securing it if necessary with a clip. 2. Hooked over the edge of the sink using the special curved plastic guide provided. 3. To a wall outlet provided with vent-hole, minimum internal dia...

Page 36 - Before plugging the appliance into the wall socket, make sure that:

Safety standards require the appliance to be earthed.The Manufacturer accepts no liability for failure to observe theabove safety precautions. 36 Extension hoses The necessary extension hoses can be obtained from specialist shops or fromour technical assistance centres. The extension hose must be no...

AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 152982 05/1 GB 152982 05/1 en 14-04-2000 11:01 Pagina 40