Addonics Technologies ST5X1PM-B - Manuals

Storage Tower Preparation Sample Inst allation on the tower using IDE hard drives • Remove the side panel screws. • Slide the side panel towards the backside then pull or lift to open. • To remove the front face panels, unscrew 2 screws on opposite sides of the 5 ¼” drive bay on the tower • This pic...

Tower with USIB connector • Any IDE or ATAPI Storage device can be converted to USB or Firewire connection via the Addonics USIB interface board and USIB interface cable. • IDE and ATAPI drives must be set as Master device. USIB back panel Inside of the USIB back panel IDE Device Installation to the...

Tower with Multilane Connector Hot swap feature depends on the SATA controller. All Addonics SATA controllers support the hot swap feature. Check with your system supplier to confirm the existing SATA port on your system supports hot swap feature. Note: It is important that you have configured your ...