Adaptec S50 - Manuals

SANBloc S50 Quick Install Guide 4 4 Remove the plastic covers from the enclosure’s rackmount ears. Caution The enclosure is heavy. To avoid personal injury, have someone help you lift it. 5 Slide the enclosure onto the rails, then push it all the way back until the rackmount ears are flush against t...

5 SANBloc S50 Quick Install Guide Installing Additional Disk Drives If the SANbloc S50 enclosure came with 4 drives installed, you can install up to 8 additional disk drives. The enclosure supports up to 12 SAS or 12 SATA disk drives, or a combination of both (up to 12 drives total). Caution Acclima...

SANBloc S50 Quick Install Guide 6 Unsupported Disk Drive Combinations Installing the Disk Drives 1 Select an open drive slot. 2 Hold the disk drive with the LEDs on the left and the lever fully open. 3 Slide the disk drive into the drive slot until the lever starts to close. Do not include SAS and S...

7 SANBloc S50 Quick Install Guide 4 Gently push the lever until it meets the latch on the left side of the drive slot and clicks into place. 5 Repeat for all remaining disk drives. Note To maintain proper airflow and cooling, a disk drive or a blank drive carrier must be installed in every slot of t...

SANBloc S50 Quick Install Guide 8 3 If you are not connecting additional SANbloc S50 enclosures, continue with “Powering On” on page 9. Connecting Additional SANbloc S50 Enclosures 1 Use an external 4x SAS cable to connect the EXP port on the first enclosure to the HOST port on a second SANbloc S50 ...

9 SANBloc S50 Quick Install Guide 2 To expand your configuration with multiple SANbloc S50 enclosures, continue to connect the EXP port of the previous enclosure to the HOST port of the next enclosure. You can connect up to seven SANbloc S50 enclosures to a single Snap Server. 3 Continue with “Power...

SANBloc S50 Quick Install Guide 3 When all SANbloc S50 enclosures are fully powered on, power on the Snap Server. Verifying that an Enclosure is Online To verify that a SANbloc S50 enclosure is online: 1 Launch a Web browser and enter the Server name or IP address of the Snap Server to which the SAN...

11 SANBloc S50 Quick Install Guide Getting Help For additional information about the SANbloc S50 SAS JBOD enclosure, refer to your Snap Server Administrator Guide or Configuration and Hardware Options Guide (on your Snap Server User CD), or the GuardianOS WebUI Help for your Snap Server. Service and...

SANBloc S50 Quick Install Guide Adaptec, Inc. Worldwide Limited Warranty The Snap Server Storage Solution hardware carries a Limited Warranty from the date of purchase as follows:Subject to the conditions below and during the Hardware Warranty Period, Adaptec will repair or replace Warranted Hardwar...

SANBloc S50 Quick Install Guide FCC Notification Authorized Ser vice Only an authorized service representative can service the Server. Failure to comply with this requirement will void the warranty. WARNING to Service Personnel The SANbloc S50 has been tested and found to comply with the limits for ...

15 SANBloc S50 Quick Install Guide Connecting to the Main Power — Install the server near an easily accessible power source. Make sure the power source is the proper voltage for your model. Place the power cord out of the way of traffic; do not place any object over the power cord. Each storage subs...

SANBloc S50 Quick Install Guide • Liquid has penetrated the server.• The server has been exposed to moisture.• The server continues to operate in an unexpected manner even after solutions suggested in the Administration Guide have been followed. Installation Cautions and Notes Caution To prevent per...