ABC Office 4107 CC - Manuals

Page 3 - Table of contents

3 Table of contents 1. General ........................................................ 4 1.1 Safety Instructions ....................................... 41.2 Application ................................................... 4 2. Installation ................................................... 5 2.1 P...

Page 4 - Safety Instructions; Non-compliance with the instructions may; Operation by one person at a time only.

4 IDEAL 4107; IDEAL 4109 1. General This instruction manual will help you to learn thesafe and comfortable operation of this machine.Please carefully read and observe the operatinginstructions and safety instructions. Thisinformation applies to both models when noreference is made. After use place t...

Page 5 - - The machine may not be installed outside.

5 2. Installation The machine is mobile on castors. The machinemust be installed on a sturdy, dry, and level floor.Oil level must be visible in the sight glass (2)IDEAL 4109 version. Danger! - The machine may not be installed outside. - Do not use in the vicinity of flammable liquids or gases.- Do n...

Page 6 - Earth wire must be available.; Checking rotating direction; mechanism by a conveyor belt.

6 IDEAL 4107; IDEAL 4109 2.2 Power supply The name plate is located at the rear of themachine.- Data stated on the name plate - Voltage “ V “,- Frequency “Hz”,- Power consumption “A”must correspond to the values of the powersupply unit. - Earth wire must be available. - Connect the machine to the ma...

Page 7 - The shredding mechanism may cause serious; Starting the machine

7 3. Operation Danger! The machine may only be operated bypersons who have read and understood theoperating instructions. Danger! Do not reach into the running shreddingmechanism! The shredding mechanism may cause serious injury! Danger! The machine will only run when the door isclosed. 3.1 Operatin...

Page 8 - Switching off the machine

8 IDEAL 4107; IDEAL 4109 Machine stops due to overloading - Remove any paper left on the conveyor belt. Do not reach behind the flap.- Press and release the yellow key (3) Conveyor belt reverses. - Feed less paper onto the conveyor belt.- Start afresh. Machine stops and yellow lamp (3) lights(IDEA...

Page 9 - Oiling the shredding mechanism

9 3.5 Oiling the shredding mechanism If the sheet capacity reduces or after “bag full“ werecommend that you oil the shredding mechanism.- Press the oilpump button 3 x.- After lubrication let the machine run several times backwards and forwards alternately. - If tank (8) is empty refill with oil. Typ...

Page 13 - - Hold bale ejecting guard with the left hand. Swing

13 Close bale- Push up locking bush (5) and swing down locking mechanism (4). - Slightly open the bale ejecting guard (2) with both hands until the lug (14) is above the locking catch(15). - Hold bale ejecting guard with the left hand. Swing locking lever (2) with the right hand until it isalmost in...

Page 14 - - The baler is equipped with a central lubrication

14 IDEAL 4107; IDEAL 4109 - Important! Lock safety slide (1). (Pull back and turn up.). 3.8 Premature ejecting of bale (IDEAL 4109) - Push knob (16) with pen or similar.- Further procedure as described in 3.7 “Operation of baler“. 3.9 Central lubrication (IDEAL 4109) - The baler is equipped with a c...

ABC Office 4107 CC - Manuals

Manuals:

Manual ABC Office 4107 CC

Summary

ABC Office Manuals