Page 2 - MR2180UA; OWNER’S MANUAL; Mobile Audio System
1 MR2180UA OWNER’S MANUAL Mobile Audio System y PLL Synthesizer Stereo Radio y CD/MP3/WMA Player y RBDS Operation y Automatic Memory Storing y Preset Equalization y Electronic Shockproof (ESP) Function y USB Interface y Auxiliary Input Function y Remote Control
Page 3 - CONTENTS
2 CONTENTS Installation ........................................... 3 Take out screw before installation ......... 3 Wiring Connection .............................. 4 Operation ............................................. 5 Location of keys .................................... 5 Basic operation .....
Page 4 - INSTALLATION
3 INSTALLATION Notes: y Choose the mounting location where the unit will not interfere with the normal driving function of the driver. y Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. y Use o...
Page 5 - WIRING CONNECTION
4 WIRING CONNECTION Connector A 1. N.C. 2. N.C. 3. N.C. 4. MEMORY +12V (YELLOW) 5. AUTO ANTENNA OUTPUT (BLUE) 6. N.C. 7. +12V (TO IGNITION KEY) (RED) 8. GROUND (BLACK) Connector B 1. REAR RIGHT SPEAKER (+) (VIOLET) 2. REAR RIGHT SPEAKER (-) (VIOLET/BLACK) 3. FRONT RIGHT SPEAKER (+) (GRAY) 4. FRONT R...
Page 6 - OPERATION
5 OPERATION LOCATION OF KEYS 1. EQ button 2. (power) button 3. Remote sensor 4. Liquid crystal display 5. BND/LOUD/ENT button 6. AS/PS button 7. DISP button 8. PTY button 9. MOD/SW button 10. AF/MUTE button 11. TA button 12. 6 DIR+ 13. 5 DIR- 14. 1-6 preset buttons 15. 4 SHF button 16. 3 RPT button ...
Page 7 - BASIC OPERATION
6 OPERATION BASIC OPERATION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (26)). When system is on, press button (2) to turn off the unit. FACEPLATE RELEASE Press OPEN button (27), then the faceplate will be folded down. SOUND ADJUSTMENT Press SEL button (21) sho...
Page 8 - RADIO OPERATION
7 OPERATION ESP FUNCTION The unit can be shockproof about ten seconds. REMOTE SENSOR Point the remote control handset to the remote sensor (3). Press the function keys on the handset to control the system. RESET FUNCTION Reset button (25) must be activated with either a ballpoint pen or thin metal o...
Page 10 - USB PLAY OPERATION
9 OPERATION BND/LOU/ENT button (5) to start playing the track.
Searching Directory or File Name Press AS/PS button (6) for two times. It enters into “Searching Directory or File Name” in Digital Audio CD. The unit searches files and directories that have the same character which is inputted by VOL...
Page 11 - DISC NOTES
10 OPERATION operation may cause file loss. And our company assumes no responsibility for this. DISC NOTES A. Notes on discs: 1. Attempting to use non-standard shape discs (e.g. square, start, heart) may damage the unit. Be sure to use round shape CD discs only for this unit. 2. Do not stick paper o...
Page 12 - REMOTE CONTROL
11 REMOTE CONTROL 1. VOL+: Volume Up Button (Character Select (A, B~8,9,0, _,-,+) For MP3/WMA Operation) 2. : Power ON/OFF Button 3. SEL: Sound Mode Select Button (Character Shift Right For MP3/WMA Operation) 4. TUNE/SKIP : Tune/Seek Down Button 5. DISP: Display Button 6. VOL-: Volume Down Button (C...
Page 13 - SPECIFICATION
12 SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ±10 dB - Treble (at 10 kHz) : ±10 dB Maximum Output Power : 4x80 watts Current Drain : 15 Ampere (max.) CD PLAYER Signal to Noise Ratio...
Page 14 - TROUBLE SHOOTING
13 TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom Cause Solution No power. The ignition switch is not on. If the power supply is connected to the car accessory ci...